Bosch Dishwashers User Manual download pdf (Page 10)

DISHWASHER PREPARATION (continued)

Figure 12

Toe

Panel

Plastic Base

Access Panel

Dishwasher Preparation

Figure 14

Figure 15

Remove Screw

Figure 13

Junction

Box

Cover

Removing the Toe Panel

Regular Toe Panel

The toe panel is loosely attached with tape. Remove the

tape and pull the toe panel away from the dishwasher. Set

the toe panel aside. It will be reinstalled later.

Plastic Base Access Panel and Toe Panel (SHY66C,

SHX99A, SHE66C, SHE99C and SHX57C models only)

The plastic base access panel and toe panel are in place

on the dishwasher, but are not attached. Remove the toe

panel first, as shown in Figure 12, then remove the

plastic base access panel, as shown in Figure 12.

When any covers are removed or the dishwasher

is out of the cabinet, electrical power and sharp

edges or points may be exposed.

Installing the 90° Elbow Fitting

NOTE: The 90° elbow fitting is not supplied with the

dishwasher, and must be purchased separately. If the

dishwasher’s hot water supply line is to be copper tubing,

make certain the elbow has a compression fitting.

Apply Teflon tape or other pipe sealant when required.

Orient the hot water supply connection leg of the elbow

toward the channel opening in the dishwasher base. See

Figure 13.

Junction Box Preparation

1 Remove junction box cover (see Figure 14) by lifting

the junction box cover up and off.

2 Remove the strain relief plate by removing the screw

at the back of the junction box, as shown in Figure

15 and sliding the strain relief plate out.

3 Set the junction box cover, strain relief plate, and

screw aside. They will be re-installed later.

Do not overtighten the 90° elbow. Doing so may

damage the water inlet valve and cause a water

leak.

CAUTION

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Comments to this Manuals

No comments

Bosch Dishwashers User Manual Page 10

Comments to this Manuals

Related products and manuals for Dishwashers Bosch Dishwashers