Bosch SGV45E03UC User Manual download pdf (Page 11)

Rinse Agent Dispenser

Open the rinse agent dispenser by lifting the tab with your thumb as shown in Figure 17.

NOTE: The dishwasher indicates low rinse agent by showing the symbol in the

countdown display.

Add liquid rinse agent to the dispenser as shown in Figure 18 until the rinse agent reservoir

is full. Wipe up any excess rinse agent that puddles when the dispenser reservoir is full.

NOTE: After lling the rinse agent dispenser, the indicator light will go out in a few

minutes after the dishwasher door is shut (select models only).

Operating the Dishwasher

Always make sure your dishware is dishwasher safe. Refer to the Dishware Materials

section of this manual for guidance.

Wash Cycles

Power Scrub Plus

Cleans items having baked-on or hard dried-on food soils. These items may require soaking

or hand scouring.

Auto

Takes the guesswork out of cycle selection. Sensors adujst cycle length, temperature and

water changes based on the soil load. This cycle is appropriate for mixed loads.

Regular

Thoroughly cleans large loads having loosely attached normal soiling.

Quick Wash

For lightly soiled items with easy to remove food soils.

Wash Cycle Options

Half Load

In the Power Scrub Plus, Regular and Auto Wash cycles you can reduce the energy and

water consumption when washing small, lightly soiled loads that ll approximately half of

the dishwasher’s capacity. To activate, select the Half Load button in addition to the Power

Scrub Plus, Regular or Auto Wash cycle button.

Extra Dry Heat

With this option you can raise the temperature of the rinse water and increase the drying

time which will result in improved drying.

To activate:

· Press and hold the left “Cancel Drain” button, then press and hold the On/Off button.

· When the LED display shows a “00” or a “01” release both buttons.

· To enable the Additional Drying Heat, press the left “Cancel Drain” button until the LED

display shows a “01”.

· To disable the Additional Drying Heat, press the left “Cancel Drain” button until the LED

display shows a “00”.

· Press the On/Off button to save the setting.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 63 64

No comments

Bosch SGV45E03UC User Manual Page 11