Bosch SHE53T52UC User Manual download pdf (Page 22)

21

Dishes are

not getting

clean

enough

1. Spray arm movement obstructed

2. Spray arm nozzles clogged

3. Improper use of detergents

4. Filters could be clogged

5. Dishes are nested or loaded too close

together

6. Selected wash cycle is not suitable for

food soil conditions

1. Ensure that spray arm movement is not

blocked by hand rotating spray arms

before starting cycle

2. Remove the spray arms and clean

according to the “Care and Mainte-

nance” section of the manual

3. Increase or decrease detergent

depending on the water hardness (refer

to Table 1)

4. Clean the filters according to the

“Care and Maintenance” section of the

manual

5. Rearrange load such that water spray

can reach all items in the dishwasher -

see “Loading the Dishwasher” section

of the manual

6. Refer to “Wash Cycle Information” sec-

tion of the manual.

Streaks on

glassware

or residue

on the

dishes

1. Incorrect rinse aid setting 1. Depending on the hardness of

water, adjust the rinse agent dis-

penser. Refer to “Adding Detergent

and Rinse Aid” section of the manual

Odor 1. Food debris is present at the bottom

of the dishwasher

2. Food particles are present near the

door seal

3. Dishes left in unit too long before run-

ning a cycle

4. Residual water is present at the bottom

of the dishwasher

5. Drain hose is obstructed

1. Remove the filters and clean accord-

ing to the “Care and Maintenance” sec-

tion of the manual

2. Refer to “Care and Maintenance” sec-

tion of the manual

3. Run a Rinse cycle if you do not intend

to immediately wash the dishes

4. Ensure the unit has completely drained

from the last cycle

5. Remove any obstructions from the

drain hose by calling qualified personnel.

Note: If odor still persists, run the Nor-

mal/Regular cycle until it flushes and

interrupt the cycle and place an 8oz.

cup of distilled white vinegar solution

on the top rack and then finish the

cycle.

Dishwasher

not filling

with water

or “Check

water sup-

ply” display

lights up

1. Restriction in the water supply sys-

tem

2. Previous wash cycle was not com-

pleted

3. Delay start is active

4. Household water supply turned off

1. Ensure that the water supply valve

(typically located under kitchen sink) is

open and check that the water supply

line has no kinks or clogs

2. Refer to the “Operating the Dish-

washer” section of the manual

3. Cancel the delay start or wait until

delay start time completes

4. Turn on water supply

Problem Cause Action

1 ... 21 22 23 ... 79

Comments to this Manuals

No comments