Bosch KIS87AF30 Operations Instructions download pdf (Page 6)

en

6

Ventilation

The air on the rear panel of the appliance

heats up. Conduction of the heated air

must not be obstructed.

Otherwise, the refrigeration unit must

work harder. This increases power

consumption. Therefore: Never cover

or block the ventilation openings!

Cavity depth

A cavity depth of 560 mm is

recommended for the appliance.

If the cavity depth is smaller –

at least 550 mm – the energy

consumption increases slightly.

Installation location

Install the appliance in a dry, well

ventilated room. The installation location

should neither be exposed to direct

sunlight nor near a heat source, e. g.

a cooker, radiator, etc. If installation

next to a heat source is unavoidable,

use a suitable insulating plate or observe

the following minimum distances to a

heat source:

■ 3 cm to electric or gas cookers.

■ 30 cm to an oil or coal-fired cooker.

Connecting

the appliance

After installing the appliance, wait at least

1 hour until the appliance is switched on.

During transportation the oil in the

compressor may have flowed into the

refrigeration system.

Before switching on the appliance for

the first time, clean the interior of

the appliance (see chapter “Cleaning

the appliance”).

Electrical connection

The socket must be near the appliance

and also freely accessible following

installation of the appliance.

The appliance complies with the

protection class I. Connect the appliance

to 220–240 V/50 Hz alternating current

via a correctly installed socket with

protective conductor. The socket must

be fused with a 10 to 16 A fuse.

For appliances operated in non-

European countries, check whether the

stated voltage and current type match

the values of your mains supply.

This information can be found on

the rating plate. Fig. .

ã=Warning

Never connect the appliance to

electronic energy saver plugs.

Our appliances can be used with mains

and sine-controlled inverters.

Mains-controlled inverters are used for

photovoltaic systems which are

connected directly to the national grid.

Sine-controlled inverters must be used

for isolated applications (e.g. on ships or

in mountain lodges) which are not

connected directly to the national grid.

1 2 3 4 5 6 7 8 9 10 11 ... 25 26

Comments to this Manuals

No comments