Bosch GLM 40 Use and Care Manual download pdf (Page 10)

-10-

intense sunlight), it may be

necessary to use the target

plate.

B) For measurements from

the rear measuring-tool edge.

In unfavorable conditions

(e.g. at intense sunlight or an

insufficiently reflecting surface),

the maximum deviation is

±10mm per 50m. In favorable

conditions, a deviation influence

of ±0.05mm/m must be taken

into account.

C) In the continuous

measurement function, the

maximum operating temperature

is +104 °F.

D) Fewer measurements are

possible when using 1.2V

rechargeable batteries than with

1.5V batteries. The battery life

listed refers to measurements

without display illumination.

Please observe the article

number on the type plate of your

measuring tool. The trade names

of the individual measuring tools

may vary.

The measuring tool can be

clearly identified with the serial

number 13 on the type plate.

Preparation

INSERTING / REPLACING THE

BATTERY

Using alkali-manganese

batteries is recommended for

operation of the measuring tool.

Fewer measurements are

possible when using 1.2V

rechargeable batteries than with

1.5V batteries.

To open the battery lid 10, press

the latch 15 and remove the

battery lid. Insert the batteries.

When inserting, pay attention to

the correct polarity according to

the representation on the inside

of the battery compartment.

When the battery symbol

appears for the first time on the

display, at least 100individual

measurements are still possible.

The continuous measurement

mode is deactivated.

When the battery symbol

flashes, the batteries must be

replaced. Measurements are no

longer possible.

Always replace

all batteries

at the same time. Do not use

different brands or types of

batteries together.

Remove the batteries from

the measuring tool when not

using it for longer periods.

When storing for longer periods,

the batteries can corrode and

discharge themselves.

!

WARNING

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 51 52

Comments to this Manuals

No comments