Bosch HBC53R550 Instruction Manual download pdf (Page 12)

Cleaning system

The cleaning system regenerates the self-cleaning surfaces in

the cooking compartment.

The back wall, ceiling and side walls of the cooking

compartment are coated with a highly porous ceramic layer.

This coating absorbs and disintegrates splashes from baking

and roasting while the oven is in operation. If these self-

cleaning surfaces no longer clean themselves adequately, they

can be regenerated with the cleaning system.

Before cleaning

Remove accessories and cookware from the cooking

compartment.

Cleaning the cooking compartment floor

Before you set the cleaning system, clean the surfaces in the

cooking compartment that are not self-cleaning. Otherwise,

stains will develop that it is not possible to remove.

Use a dish cloth and hot soapy water or a vinegar solution. If

there are heavy deposits of dirt, use a stainless steel scouring

pad or oven cleaner. Only use when the cooking compartment

is cold. Never treat the self-cleaning surfaces with a scouring

pad or oven cleaner.

Making settings

Cleaning takes approximately one hour.

1. Set the function selector to < 3D hot air.

2. Set the temperature selector to s.

3. Press theu button.

The

u symbol lights up in the display. The time at which the

cleaning will end appears and the

p symbol is in brackets.

Cleaning will start after a few seconds. You will see the time

counting down and the

r symbol will be in brackets. The p

symbol goes out.

Cleaning is finished

A signal sounds. The oven stops heating. 00:00 is shown in the

display. Press the

0 button twice and turn the function selector

to the off position. The oven switches off.

Cancelling cleaning

Press the

u button and turn the function selector to the off

position. The oven switches off.

Setting a later end time

You can delay the time at which the cleaning programme is due

to finish. For instance, you can set the cleaning programme to

run at night so that you can use your oven during the day.

Make the settings as described in steps 1 to 3. Before cleaning

starts, use the

@ or A button to set a later end time.

The oven switches to standby. The display shows the time at

which the cleaning will finish and the

p symbol is in brackets.

When cleaning starts, you can see the time counting down in

the display and the

r symbol is in brackets. The p symbol

goes out.

After cleaning

When the cooking compartment has cooled down completely,

wipe the salt residues off the self-cleaning surfaces with a

damp cloth.

Troubleshooting

Malfunctions often have simple explanations. Refer to the table

before calling the after-sales service as you may be able to

remedy the fault yourself.

Malfunction table

If a dish doesn't turn out as well as you had hoped, refer to the

section Tested for you in our cooking studio, where you will

find plenty of cooking tips and tricks.

Error messages

If an error message with

“ appears, press the 0 button. The

message disappears. A time function that has been set is

cleared. If the error message does not disappear, please

contact the after-sales service.

You can take remedial action yourself if the following error

message is displayed.

ã=Risk of electric shock!

Incorrect repairs are dangerous. Repairs may only be carried

out by one of our trained after-sales engineers.

Replacing the oven light bulb

Replace faulty oven light bulbs.

You can obtain replacement light bulbs from customer service

or specialist retailers: E14, 220 - 240 V, 40 W, heat resistant to

300 °C. Only use these oven light bulbs.

ã=Risk of electric shock !

Disconnect the appliance from the power supply. Switch off the

circuit breaker or remove the fuse from the household fuse box.

Problem Possible cause Remedy/information

The oven does

not work.

The circuit

breaker is

defective.

Look in the fuse box and

check that the circuit

breaker is in working order.

Power cut Check whether the kitchen

light or other kitchen appli-

ances are working.

0 and zeros

light up in the

display.

Power cut Reset the clock.

The oven does

not heat up.

There is dust on

the contacts.

Turn the control knobs back

and forth several times.

Error message Possible cause Remedy/information

“‹‚‚

A button was

depressed for

too long or is

covered up.

Press all buttons individu-

ally. Check whether any but-

tons are jammed, covered

up or soiled.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Comments to this Manuals

No comments

Bosch HBC53R550 Instruction Manual Page 12

Comments to this Manuals

Related products and manuals for Ovens Bosch HBC53R550