Bosch HTH182 Specifications download pdf (Page 12)

-12-

• Hardness of the material to be joined.

• Lubricating effect at the surfaces of the

junction.

This leads to the following application cases:

->0/-?1 The joining of metal to metal with a

disk washer. The maximum torque is reached

after a relative short impacting/tightening

action.

105A9 /-?1 The joining of metal to metal

where spring ring washer, disk spring washer,

stud bolts or bolts/nuts with conical seats are

used.

%;2@/-?1 The joining of e.g. metal to wood

or insulation material.

For middle or soft joining cases, the maximum

tightening torque is less as for hard cases.

Therefore, a longer impacting/tightening action

is necessary to arrive at the maximum tightening

torque.

!)&$'%G

Due to the lubrication used in the impacting

mechanism, the tool should be run for three

minutes at no load prior to actual usage. This

will warm the lubricant and provide better

performance.

Set Forward/Reversing lever to the center (off

position). Slide charged battery pack into the

housing until the battery pack locks into

position (Fig. 6)

Your tool is equipped with a secondary locking

latch to prevent the battery pack from

completely falling out of the handle, should it

become loose due to vibration.

To remove the battery pack, press the battery

pack release button and slide the battery pack

forward.

Press the battery pack release button again

and slide the battery pack completely out of

tool housing (Fig. 6).

 %$&  $% &&$+"

FIG. 6

1. The charger was designed to fast charge

the battery only when the battery temperature

is between 32˚F (0˚C) and 113˚F (45˚C). If the

battery pack is too hot or too cold, the charger

will not fast charge the battery. (This may

happen if the battery pack is hot from heavy

use). When the battery temperature returns to

between 32˚F (0˚C) and 113˚F (45˚C), the

charger will automatically begin charging.

2. A substantial drop in operating time per

charge may mean that the battery pack is

nearing the end of its life and should be

replaced.

3. Remember to unplug charger during storage

period.

4. If battery does not charge properly:

a. Check for voltage at outlet by plugging in

some other electrical device.

b. Check to see if outlet is connected to a

light switch which turns power “off” when lights

are turned off.

c. Check battery pack terminals for dirt.

Clean with cotton swab and alcohol if

necessary.

d. If you still do not get proper charging,

take or send tool, battery pack and charger to

your local Bosch Service Center. See “Tools,

Electric” in the Yellow Pages for names and

addresses.

;@1 Use of chargers or battery packs not

sold by Bosch will void the warranty.

"!$& &$  !&%

BM 2610007821 11-09:BM 2610007821 11-09 11/3/09 6:48 AM Page 12

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 43 44

Comments to this Manuals

No comments