Bosch MIC400 Specifications download pdf (Page 8)

VIP X1 to MIC400 | Connection Guide AEN| 8

Bosch Security Systems Issue 1

Turning on/off

The VIP X includes a mains power supply with four primary adaptors and terminal

block. The VIP X does not have a power switch; the unit is ready for operation as

soon as the power is connected.

Using the power supply unit cable connect the terminal block to the orange jack on

the VIP X.

Ensure that the correct primary adapter is attached to the power supply unit and an

appropriate mains socket is available.

Plug the power supply unit into a grounded mains socket. The unit is ready for

operation as soon as the “operating status” LED stops flashing red during start up

and is lit green.

If the network connection is in order, the green LED L is also lit. The flashing

orange LED T indicates data traffic on the network.

Terminal Block Connections

The terminal block is used to connect external signal sources or alarm switches, as

a relay output, a serial interface or as a power supply.

Options for using the serial interface include transparent data transfer, control of

connected devices or operation of the unit with a terminal program. Depending on

the configuration settings, the serial interface uses the RS232 or RS422/485

standards.

The pin assignments and functions are shown below:-

Pin Assignment

WARNING: To operate the VIP X use only the power

supply unit supplied with the correct primary adaptor for

your mains socket. Use suitable equipment when

necessary to ensure the mains supply is clean and free

from voltage surges, spikes or voltage drops.

WARNING: Connect VIP X only after everything else is

connected.

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Bosch MIC400 Specifications Page 8