Bosch MIC400 Specifications download pdf (Page 9)

VIP X1 to MIC400 | Connection Guide AEN| 9

Bosch Security Systems Issue 1

The pin assignment for the serial interface depends on the standard used, these

are detailed below:-

Connecting the MIC400 camera

The MIC400 camera is connected to the VIP X via twin shielded twisted pair cable

for the telemetry signals and coaxial cable with a BNC connector for the video feed

from the MIC400 power supply unit.

A typical installation with connections is shown alongside.

Pelco D/P or Bosch protocol should be loaded into the MIC400 camera.

Once connected, power the camera and the VIP X unit and you can now access

your camera via the Ethernet connection using either a terminal program or the

integrated web browser.

Configuring the MIC400 Camera

The VIP X1/X2 contains an integrated HTTP server which allows the unit to be

configured over the network via a web browser.

Please refer to the VIPX1/VIP X2 Installation and User guide for details on

installation and operation of this software.

The user manual is for the VIP X1/ VIP X2 network video server is on the CD that

comes with the VIP X unit or can be downloaded for the URL below:-

http://office.manualsonline.com/manuals/mfg/bosch/bosch_network_device_produ

ct_list.html

Pin RS232 Standard RS422/485 Standard

IN1 Alarm Input 1 Alarm Input 1

IN2 Alarm Input 2 Alarm Input 2

IN3 Alarm Input 3 Alarm Input 3

IN4 Alarm Input 4 Alarm Input 4

GND GND (ground) GND (ground)

R (Top) Relay Relay

R (Bottom) Relay Relay

CTS CTS (clear to send) RxD- (receive data minus)

RTS RTS (ready to send) TxD- (transmit minus)

RXD RxD (receive data) RxD+ (receive data plus)

TXD TxD (transmit data) TxD+ (receive data plus)

+ 12 V (power supply) 12 V (power supply)

- GND (ground) GND (ground)

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Bosch MIC400 Specifications Page 9