Bosch Solution 16plus Specifications download pdf (Page 17)

Zone Indicator Description

Battery Fail

Date & Time

Sensor Watch

Horn Speaker Fail

Telephone Line Fail

E2 Fault

Zone 16 In Alarm (Partitioned Systems Only)

Communication Fail

Table 7: Fault Indicators

Fault Descriptions

Low Battery

A low battery fault will register when the system detects a low capacity back-up battery.

The system automatically performs a battery test every 4 hours and also every time you arm

the system.

Date and Time

The date and time fault will register every time the system has been powered down. This

type of fault will not cause the FAULT indicator to display on the codepad unless your

installer has programmed the automatic arming time. Refer to page 18 to program the date

and time.

Sensor Watch

A sensor watch fault will register because one or more detection devices has failed to detect

any movement during the disarmed state for the time period programmed by your installer.

The fault will clear once the zone in question has detected movement and reset.

Whilst you are in fault analysis mode, press and hold button 5 until two beeps are heard will

display which zone reported the sensor watch fault.

Horn Speaker Fail

This fault will register when the system detects that the horn speaker has been disconnected.

This fault will clear once the horn speaker has been reconnected. Your installer will need to

program the system for this feature to operate.

Telephone Line Fail

A telephone line fault will register when the system detects that the telephone line has been

disconnected from the control panel. Your installer will need to program the system for this

feature to operate.

E2 Fault

An E2 fault will register when the system detects an internal checksum error. Contact your

installer as soon as this fault is displayed.

!"#$%&"'()* Operators Manual 17

Electronics Design and Manufacturing Pty Limited ISSUE160.DOC

1 ... 16 17 18 ... 44

No comments

Bosch Solution 16plus Specifications Page 17