Bosch Solution 16plus Specifications download pdf (Page 29)

Basic Pager Reporting

This feature is only applicable if your system is reporting to a pocket pager. Basic pager

reporting requires some interpretation of the numbers that appear of the display. However, it

is possible to differentiate between 1000 different systems when a number of control panels

are reporting to the one pocket pager.

Basic Pager Display Information

Subscriber ID Number

This is the identification number of the control panel and can only be programmed by your

installer.

Zone Status

The zone status display shows you the status of each zone (1 – 8). The following table

describes what each number means when displayed on the zone status display.

Number

Displayed

Zone

Description

Zone Normal

This indicates that the corresponding zone is in the sealed state.

Alarm

This indicates that the corresponding zone is unsealed and in alarm

condition.

Zone Bypassed

This indicates that a system operator has manually isolated the

corresponding zone. Refer to Isolating Zones on page 15 for information

on how to manually isolate a zone(s) prior to arming the system.

Zone Trouble

This indicates that a zone was left unsealed after the end of exit time.

Table 10: Zone Status Display Descriptions

System Status

The system status information is divided up into 4 digits. The first digit of the system status

display indicates whether the system is armed or disarmed (8=Disarmed / 9 = Armed).

The second digit on the system status display indicates which codepad alarm was triggered

by the operator (0 = No Codepad Alarm / 1 = Codepad Panic or Duress Alarm / 2 = Codepad

Fire Alarm / 3 = Codepad Medical Alarm).

The third digit on the system status display indicates when the AC mains supply has failed (0

= AC Supply is normal / 1 = AC Supply has failed).

The fourth digit on the system status display indicates when a system fault has occurred at

the control panel (0 = System Normal – There is no faults / 1 = System Fault – There is a

fault registered by the control panel).

!"#$%&"'()* Operators Manual 29

Electronics Design and Manufacturing Pty Limited ISSUE160.DOC

1 ... 28 29 30 ... 44

No comments

Bosch Solution 16plus Specifications Page 29