Bosch Vision 300 Operating User Manual download pdf (Page 18)

18 en | Standard Controls Universal Camera Setup Software

F.01U.172.623 | 1.0 | 2011.10 User Manual Bosch Security Systems, Inc.

Other protocols use an add point method, where Start Recording and Stop Recording are

used in the same way, but instead of manual control in the middle, Add Tour Point is used to

insert a preset position with the options specified: Preset, Dwell and Speed.

4.8 Reset MIC

Accessed from File > Reset MIC, this sends out a command to reboot the software. This is not

a hardware reboot. The only way to reboot the hardware is to remove the power supply to the

MIC. The software reboot will take approximately 10 to 15 seconds, depending on the

software loaded.

4.9 Resetting Default Values After a Protocol Change

After any protocol change or a firmware (FW) upgrade, MIC cameras MUST be reset to their

default values. For Camset 4.0, follow these steps:

1. Open the Universal Camset software.

2. Set the appropriate values in the Cam-set Protocol, MIC Model, and IP Address fields (at

the bottom left of the main window).

3. Test for control. If control is not possible, repower the unit and check the camera

address on the Video Out or in the Boot Messages box. The address is sometimes

changed during the protocol changes. For example, when changing protocols from Pelco

to Bosch, the MIC address is changed to 54; the unit will not Pan left, and will only Tilt in

one direction.

4. Select Settings > General Control.

5. Click the Clear button under both Soft Stops and Non-Dwell Zone sections of the

window, and then click the Find End Stops button.

6. Select Settings > Default Loader.

1 ... 17 18 19 ... 52

No comments

Bosch Vision 300 Operating User Manual Page 18