Bosch 15SBI Service Manual download pdf (Page 14)

Lift the appliance against the wall to engage in the top support

plate and lower onto the manifold assembly. Refer to Fig. 17.

Tighten the gas and water connections. Lower the facia and fit a

discharge pipe to the relief valve leading it away from any electric's.

The pipe must not be less than 15mm in diameter and must run

continuously downward outside the appliance. Refer to Fig 47.

If the optional internally fitted diverter valve is to be connected

then full instructions are sent with the valve. Refer to Fig. 20.

11.7 Air and Flue Duct Preparation

The method of installation of the flue system may be varied to

suit the actual site conditions. The instructions for connecting

and fixing the ducts must, however, be strictly followed.

Unpack the flue spigot, restrictor ring and clamping rings from the

Flue Spigot Kit in the boiler Installation Pack. Fit the spigot to the

boiler top panel with the four screws provided in the Flue Spigot Kit.

IMPOR

TANT Check the maximum flue length and if it is less than 1m

total overall length then fit the restrictor ring as shown in Fig. 21

24SBi - 75mm Horizontal flue up to 1m

- 75mm Vertical flue up to 1m

15SBi - 74mm Horizontal flue up to 1m

- 79mm Vertical flue up to 1m

The standard telescopic flue assembly is suitable for flues from

425mm up to 725mm measured from the centre-line of the

boiler flue outlet to the outer face of the wall. Refer to Fig.22.

Fig. 17 . Fixing the appliance to the wall mounting plate.

Appliance

Pre-plumbing

manifold

Keep

Appliance

Vertical

Step. 1

Rest the appliance on

the pre-plumbing

manifold and push

backwards engaging

the valves.

Check that all the

O-Rings are in place.

Step. 2

Secure the top with

M6 nuts and washers

(2).

Step.3

Secure the bottom

with the caps and

washers (3).

Fig.18. Appliance casing and control

equipment fixings.

Inner casing

cover

screws (4)

Side casing

fixing

screws (4)

Facia panel

fixing

screws (2)

Connections

cover fixing

screws (3)

24SBi

Fig.19. Flow manifold assembly

IMPORTANT

DO NOT REMOVE

THIS CLIP!

1. Flow manifold assembly

2. Connector

3. Clips (Removable)

4. Assembly mounting

plate

5. Filling Loop

6. Protection cap

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 36 37

Comments to this Manuals

No comments

Bosch 15SBI Service Manual Page 14

Comments to this Manuals

Related products and manuals for Water heaters & boilers Bosch 15SBI