Bosch 520-PN-L Specifications Page 11

  • Download
  • Add to my manuals
  • Print
  • Page
    / 36
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 10
6 720 644 942 (2014/11)520 HN
Installation instructions | 11
Fig. 4 Minimum clearances
4 Installation instructions
4.1 Introduction
Please follow these instructions. Failure to follow instructions
may result in:
Damage or injury.
Improper operation.
Loss of warranty.
If you are unable to perform the tasks required to install this
heater properly, please contact a locally licensed plumber or
gas technician.
Please contact Bosch Water Heating with any questions.
4.2 Proper location for installing your heater
Carefully select the location of the water heater. For your safety
and for proper heater operation, you must provide combustion
air to the heater and a proper exhaust vent system.
Follow the guidelines below:
1. Common installation practice is to determine the venting
system layout and penetration first, then work back to the
heater.
2. Locate the heater where venting, gas and plumbing
connections are feasible and convenient.
3. The hot water lines should be kept short to save energy.
Centrally locating the water heater is best. It is always best
to have hot water lines insulated.
4.3 Mounting Heater
The 520 HN is approved for installation on a combustible wall
provided the floor covering below the heater is
noncombustible. For installations in an alcove or closet,
maintain the minimum clearances to combustible and non-
combustible materials listed in Fig. 4.
Model 520 HN
TOP (A) 12 inches (306 mm)
FRONT (B) 4 inches (100 mm)
BACK 0 inches
SIDES 4 inches (100mm)
BOTTOM (C) 12 inches (306 mm)
Table 4
WARNING:
The water in this water heater is cold and
always remains cold except for the times
that hot water is being used.
DO NOT INSTALL IN AN AREA WHERE
IT COULD FREEZE.
Drain the heater entirely if freezing
temperatures are anticipated in area
where heater is installed. See chapter
5.6 for draining instructions.
To prevent freeze damage from residual
water in the heater, introduce short
bursts of compressed air (20-40psi)
through these connections to remove
the residual water in the horizontal
pipes and water valve.
WARNING:
Flammable materials, gasoline,
pressurized containers, or any other
items or articles that are potential fire
hazards must NOT be placed on or
adjacent to the heater. The appliance
area must be kept free of all combustible
materials, gasoline and other flammable
vapors and liquids.
WARNING:
Place the heater in a location where
water leaks will do NO DAMAGE to
adjacent areas.
Page view 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 35 36

Comments to this Manuals

No comments