29
Introduction to DSC
Diagnosis
The following diagnostic functions are available using the DISplus or GT-1.
Control Unit Functions:
Expert mode diagnosis available
at any time during troubleshoot-
ing. To enter: press the Control
Unit Functions button at the
right lower corner of the screen.
The contents are:
• Identification
• Delete Fault Memory
• Read Fault Memory
• Component Activation
• Status queries (requests)
Service Functions:
Provides access to specialized test modules
used as post repair procedures. To enter:
• Function Selection
• Service Functions
• Chassis
• Dynamic Stability Control
The contents are:
• Connection Speed Sensor: A test to
verify the proper wiring to the wheel
speed sensors
• Connection Brake Lines: A test to
verify the proper brake pipe connections
to the hydraulic unit.
• Adjustment Functions: Test modules
to initialize certain components after
repair work is performed
• Steering Angle Sensor
• Lateral Acceleration Sensor
• Pressure Sensors
Test Modules: Faults with the DSC III system can be diagnosed using fault or symptom driven test
modules. To begin diagnosis:
• Perform the Quick Test.
• Select Vehicle Symptom from the Symptom Selection page.
• Select Test Module from Test Plan page.
• Press the Test Schedule Button.
Comments to this Manuals