Bosch DKE606A Installation Manual download pdf (Page 12)

12

Fixed installation:

The fixed installation can be carried out by a

qualified and authorized person only.

Envisage an omnipolar switch having a

contact opening of at least 3mm, including an

automatic circuit breaker.

The cable must be replaced by the

manufacturer, the assistance centre or a

qualified and authorized person only, in

order to avoid any dangers.

Electrical data:

The technical data of the device are on the

distinctive label inside the device behind the

grease filters.

In case of repair, disconnect the electric

supply from the cooker hood.

Length of the feeding cable: 1,30m.

The hood complies with the EMC directives.

Installation

This extractor hood is intended to be

mounted onto the kitchen wall.

WARNING! Do not connect the

appliance to the mains until the installation is

fully complete.

Note: Take into account any special

accessories that are going to be fitted.

1. Remove the grease filter (refer to

Operating Instructions).

min.

600 Elektro

650 Gas

2. Draw a line on the wall from the ceiling to

the lower edge of the hood at the centre

of the location where the hood is going to

be mounted.

3. Using the template, mark positions on the

wall for the screws.

4. Drill 2 holes (dia. 8 mm) for the extractor

hood.

Drill 2 holes (dia. 8 mm) for the bracket for

fixing the flue ducts - use the bracket as a

template: this should be fit close to the

ceiling so that index printed on the bracket

matches with the line previously marked

(see step 2).

Insert wall plugs flush with the wall.

Electrical connection

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 67 68

Comments to this Manuals

No comments