Bosch CS20 Specifications download pdf (Page 10)

DEPTH ADJUSTMENT

Your saw is equipped with a depth detent

system that will stop the foot at 2x, 3/4", 1/2",

and 1/4" standard lumber depths.

Disconnect plug from power source. Loosen

the depth adjustment lever located in the

housing of saw. Hold the foot down with one

hand and raise or lower saw by the handle.

Tighten lever at the depth setting desired.

Check desired depth (Fig. 3).

Your saw also features a adjustable depth

adjustment lever for consistent locking. To

adjust, simply pull outward on lever and

reposition to desired position (Fig. 3).

Not more than one tooth length of the blade

should extend below the material to be cut, for

minimum splintering (Fig. 4).

-10-

90° CUTTING ANGLE CHECK

Disconnect plug from power source. Set foot to

maximum depth of cut setting. Loosen bevel

adjustment lever, set to 0° on quadrant,

retighten lever and check for 90

° angle

between the blade and bottom plane of foot

with a square (Fig. 5). Make adjustments by

turning the small alignment screw from bottom

side of foot, if necessary.

BEVEL ADJUSTMENT

Your saw is equipped with a bevel detent

system that will stop the foot at 22.5°, and 45°

angles.

Disconnect plug from power source. The foot

can be adjusted up to 56° by loosening the

bevel adjustment lever at the front of the saw.

Align to desired angle on calibrated quadrant.

Then tighten bevel adjustment lever (Fig. 6).

Your saw also features a adjustable bevel

adjustment lever for consistent locking. To

adjust, simply pull outward on lever and

reposition to desired position (Fig. 1).

Because of the increased amount of blade

engagement in the work and decreased

stability of the foot, blade binding may occur.

Keep the saw steady and the foot firmly on the

workpiece.

Operating Instructions

FIG. 4

ONE TOOTH LENGTH SHOULD

PENETRATE WOOD FOR

MINIMUM SPLINTERING

CALIBRATED

DEPTH BRACKET

ADJUSTABLE

DEPTH LEVER

FIG. 3

QUADRANT

BEVEL

ADJUSTMENT

LEVER

FIG. 6

FIG. 5

90°

BLADE

BEVEL

ADJUSTMENT

LEVER

FOOT

ALIGNMENT

SCREW

FOOT

1

2

BM 1619X00889 3-05 3/20/05 10:01 PM Page 10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 43 44

Comments to this Manuals

No comments