Bosch BCM8450UC Instruction Manual download pdf (Page 31)

27

en

Tips on energy saving

Note:

If there is not enough descaling solution in

the water tank, you will be asked to do the

following. Refill using uncarbonated water

and press C again.

■ Remove the suction pipe from milk

container, wipe it and insert the end of the

suction pipe into the hole on the coee

grounds container.

■ Close the appliance door.

■ Place a container with a capacity of 17 oz

under the beverage outlet.

■ Press C.

The program will now run for about

19 minutes.

■ Remove the container and press C.

■ Rinse the water tank and (if removed)

replace the water lter.

■ Fill the tank with fresh water up to the

“max” indicator.

■ Replace the water tank and close the door.

■ Place the container underneath the

beverage outlet again.

■ Press C.

The program will now run for about

7 minutes and rinse the appliance.

■ Remove the container, empty the drip

trays, replace and close the appliance door.

■ Press C. The appliance is descaled,

cleaned and ready for use again.

■ Press E to exit the program.

Special rinsing

NOTICE:

If any of the service programs are ever

interrupted, for instance by a power failure,

please proceed according to the informa-

tion on the display:

■ Rinse the water tank and rell it with fresh

water up to the “max” mark.

■ Press C. The program will now run for

about 2 minutes and rinse the appliance.

■ Empty the drip trays, replace and close

the appliance door. The appliance is

ready for use again.

■ Press E to exit the program.

Tips on energy saving

■ Press I to switch the appliance to

“energy saving mode”. The appliance

uses very little power when in “energy

saving mode”, but monitors all safety-

relevant functions so as to avoid damage.

■ In the menu under “Switch off after”,

set the automatic switch o period to

15 minutes.

■ Reduce the brightness of the display

and the illumination in the menu to save

energy.

■ If possible, do not interrupt the dispensing

of coee or milk froth. Stopping a process

prematurely results in higher energy

consumption and the drip tray lls up

more quickly.

■ Descale the appliance regularly to avoid a

build-up of limescale. Limescale residues

cause higher energy consumption.

Frost protection

To prevent frost damage during trans-

port and storage, completely empty the

appliance beforehand (see the section

“Menu – Frost protection”).

Storing accessories

The fully automatic coee machine has a

special accessory drawer for storing the

Quick reference guide and the accessories

in the appliance.

■ Put the measuring spoon and the water

lter into the accessory drawer.

■ Put the Quick Reference Guide into the

special support at the front of the acces-

sory drawer.

■ The long suction pipe can be stored

in the holder on the inside of the door

(Figure D).

■ The connecting element can be xed to

the magnetic holder above the ground

coee drawer.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 115 116

Comments to this Manuals

No comments