Bosch BCM8450UC Instruction Manual download pdf (Page 21)

17

en

Menu

■ Turn the control ring and select “00h15m”.

■ Press A. [ Save ] and [ Do not save ]

appears.

■ Press [ Save ]. The setting is saved.

The drink selection appears on the display.

Note:

Press A to exit the menu at any time. If

no entry is made within approx. 30 seconds,

the menu closes automatically and the

settings are not saved.

The following settings can be made:

Language

Set the desired language to show the

display texts.

Water hardness

Set this to the local water hardness.

Level “1 (soft)” to “4 (very hard)” can be

selected. The preset water hardness is

“4(very hard)”.

Note:

It is important to set the water hardness

correctly to enable the appliance to accu-

rately indicate when the descaling program

should be run.

You can check the water hardness using

the enclosed test strip or by asking your

local water supplier. If a water softening

system is installed in the house, please

select the “Softening device” setting.

Water filter

If a water lter is inserted, renewed or

removed, the setting “Insert”, “Replace” or

“Remove” must be made in the menu.

Note:

A water lter lowers limescale deposits,

reduces impurities in water and improves

the coee taste.

Water lters are available from retail outlets

or from customer service (see the section

“Accessories”).

Inserting or renewing a water lter:

A new water lter must be rinsed before it

can be used.

■ Turn the control ring to select either

“Insert” or “Replace”.

■ Press the water lter rmly into the

opening of the water tank.

■ Fill the water tank with cool water up to

the “max” mark.

■ Remove the milk tube from the milk

container and close the door.

NOTICE:

Do not jam the tube when closing the door.

■ Place a container with a capacity of 17 oz

under the outlet .

■ Press C.

Water will now ow through the lter to

rinse it.

■ Then empty the container.

The appliance is ready for use again.

Note:

Rinsing the lter simultaneously activates

the setting for the change lter display.

The lter is no longer eective when the

“Replace water filter” display appears, or at

the latest after two months. It needs to be

replaced for reasons of sanitation and to

prevent a build-up of limescale (which could

damage the appliance).

■ If a new lter is not inserted, select the

setting [ Remove ] and press C.

The message “Remove filter, reinsert

watertank, close door” appears.

Note:

If the appliance has not been used for a

prolonged period (for example, while you

are on vacation), the existing lter should

be rinsed before the rst time the appliance

is used again. To do this, simply dispense a

cup of hot water.

Detailed information about the water lter

can be found in the manual supplied with

the lter.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 115 116

Comments to this Manuals

No comments