Bosch BCM8450UC Instruction Manual download pdf (Page 13)

9

en

Initial use

Setting up the appliance

■ Remove any protective plastic lm.

NOTICE:

Only use the appliance in a frost-free room.

If it has been transported or stored at tem-

peratures below 32°F, wait at least 3 hours

before initial use.

■ Take hold of the appliance door by the

recessed grip and open.

■ Remove the water tank, rinse it and ll it

with fresh water up to the “max” mark.

■ Replace the water tank and click into

place.

■ Remove the bean container, ll with

coee beans and replace.

■ Set the power switch to I and close

the appliance door.

The appliance heats up and is rinsed.

The control panel is activated.

“Language” appears.

■ Turn the control ring with your nger to

select the desired language and press the

[ Water hardness ] eld.

Note:

It is important to set the water hardness

correctly to enable the appliance to accu-

rately indicate when the descaling program

should be run. The preset water hardness

is level 4. If a water softener is installed in

the house, please set the water hardness to

level 3. You can also check the water hard-

ness by asking your local water supplier.

■ Use the enclosed test strip to determine

the water hardness. Briey dip the test

strip in water and check the result after

one minute.

Level Water hardness

gr/gal (US)

1

2

3

4

1.0426 - 7.2985

8.3412 - 14.597

15.64 - 21.896

22.938 - 31.279

■ Turn the control ring with your nger to

set the water hardness determined.

■ Press [ Set-up complete ]. The settings are

saved.

The appliance is ready to use as soon

as the drink images are shown and the

m lights up.

The integrated fan switches on each time

a drink is dispensed and switches o again

after a few minutes.

Note:

When the appliance is used for the rst time

after running a service program, or if it has

not been operated for a long period, the rst

beverage will not have the full aroma.

When the fully automatic coee machine

is rst used, a suitable thick and stable

“crema” is only achieved after the rst few

cups have been dispensed.

Switch o appliance

■ Press I.

The appliance rinses and switches to

energy saving mode.

Exception: If only hot water is dispensed,

the appliance switches o without rinsing.

■ To switch the appliance o completely,

open the appliance door and set the

power switch to h.

NOTICE:

Do not press the power switch while the

appliance is in use.

Note:

The factory settings of the fully automatic

coee machine are programmed for optimal

performance. The appliance switches auto-

matically to the energy saving mode after

a specied time and rinses (duration can

be set, see “Switch o after” in the section

“Menu”).

Note:

The appliance is equipped with a sensor.

If there is a milk container, this will be

correspondingly shown on the display when

switching to the energy saving mode. If

there is milk in the container, please store in

the fridge.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 115 116

Comments to this Manuals

No comments