Bosch GPLL5 User Manual download pdf (Page 11)

Switching On and Off

To switch on the tool, press the On/Off button 15. Immediately

after switching on, the tool sends a laser beam out of the exit

opening 9.

• Do not point the laser beam at persons or animals and

do not look into the laser beam yourself, not even from a

large distance.

To switch off the tool, press the On/Off button 15 again.

• Do not leave the switched on tool unattendedand switch

the tool off after use. Other persons could be blinded by the

laser beam.

Leveling Functions

Note: The specified leveling accuracy applies for the alignment

of the laser beam with reference to the spirit levels 6 and 7.

Positioning the Tool (see figure A)

For precise alignment with the spirit levels, the position of the

tool is important.

The specified leveling accuracy is only achieved when the tool is

correctly positioned:

• For horizontal alignment with the spirit level 7, the aluminium

supporting surface 8 of the tool must face downward.

• For vertical alignment with the spirit level 6, the exit opening

for the laser beam 9 must face upward.

Aligning with the Laser Line

Horizontal Alignment (see figures B and C): Position the tool

with the three supporting points 12 against the wall or with help

of the magnets 14, fasten it to the wall holder 1 or to another

magnetic surface. The aluminium supporting surface 8 of the

tool must face downward. Align the tool horizontally with help of

the spirit level 7. Picture frames or tiles, as an example, can be

aligned alongside the horizontal laser line.

Vertical Alignment (see figure C): Position the tool with the

three supporting points 12 against the wall or with help of the

magnets 14, fasten it to the wall holder 1 or to another magnetic

surface. The exit opening for the laser beam 9 must face

upward. Align the tool vertically with help of the spirit level 6. Top

and bottom cabinets, as an example, can be aligned alongside

the vertical laser line.

Alignment off of Reference Points (see figure D): Position the

tool with the three supporting points 12 against the wall or with

help of the magnets 14, fasten it to the wall holder 1 or to

another magnetic surface. Turn the tool to any angle in order to

-11-

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 35 36

Comments to this Manuals

No comments

Bosch GPLL5 User Manual Page 11

Comments to this Manuals

Related products and manuals for Computer Accessories Bosch GPLL5