Bosch DDBB180-02-RT Use and Care Manual download pdf (Page 11)

Set Forward/Reversing lever to the center (off

position). Slide charged battery pack into the

housing until the battery pack locks into

position (Fig. 7).

Your tool is equipped with a secondary locking

latch to prevent the battery pack from

completely falling out of the handle, should it

become loose due to vibration.

To remove the battery pack, press the battery

pack release button and slide the battery pack

forward.

Press the battery pack release button again

and slide the battery pack completely out of

tool housing (Fig. 7).

-11-

FIG. 7

1. The charger was designed to fast charge

the battery only when the battery temperature

is between 32˚F (0˚C) and 113˚F (45˚C). If the

battery pack is too hot or too cold, the charger

will not fast charge the battery. (This may

happen if the battery pack is hot from heavy

use). When the battery temperature returns to

between 32˚F (0˚C) and 113˚F (45˚C), the

charger will automatically begin charging.

2. A substantial drop in operating time per

charge may mean that the battery pack is

nearing the end of its life and should be

replaced.

3. Remember to unplug charger during storage

period.

4. If battery does not charge properly:

a. Check for voltage at outlet by plugging in

some other electrical device.

b. Check to see if outlet is connected to a

light switch which turns power “off” when lights

are turned off.

c. Check battery pack terminals for dirt.

Clean with cotton swab and alcohol if

necessary.

d. If you still do not get proper charging,

take or send tool, battery pack and charger to

your local Bosch Service Center. See “Tools,

Electric” in the Yellow Pages for names and

addresses.

!;@1 Use of chargers or battery packs not

sold by Bosch will void the warranty.

 #"$&!&$!!"&%

!%$&!!$%!&&$+#

-A@5;:

The manufacturer is not responsible for radio

interference caused by unauthorized

modifications to this equipment. Such

modifications could void the user’s authority to

operate the equipment.

This device complies with Part 15 of the FCC

Rules. Operation is subject to the following

two conditions:

1) This device may not cause harmful

interference, and

2) This device must accept any interference

received, including interference that may

cause undesired operation.

!"& This equipment has been tested and

found to comply with the limits for a Class B

digital devices, pursuant to Part 15 of the FCC

rules. These limits are designed to provide

reasonable protection against harmful

interference in a residential installation. This

equipment generates uses and can radiate

radio frequency energy and, if not installed

and used in accordance with the instructions,

may cause harmful interference to radio

communications. However, there is no

guarantee that interference will not occur in a

particular installation. If this equipment does

cause harmful interference to radio or

television reception, which can be determined

by turning the equipment off and on, the user

is encouraged to try to correct the interference

by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the

equipment and receiver.

• Connect the equipment into an outlet on a

circuit different from that to which the

receiver is connected.

• Consult the dealer or an experienced

radio/TV technician for help.

BM 2610025599 05-12_BM 2610025599 05-12.qxp 5/1/12 1:42 PM Page 11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 47 48

Comments to this Manuals

No comments

Bosch DDBB180-02-RT Use and Care Manual Page 11

Comments to this Manuals

Related products and manuals for Cordless combi drills Bosch DDBB180-02-RT