Bosch DDBB180-02-RT Use and Care Manual download pdf (Page 9)

-9-

??19.8E

5?/;::1/@ .-@@1>E <-/7

2>;9 @;;8 .12;>1 9-75:3

-:E -??19.8E -06A?@91:@? ;>/4-:35:3

-//1??;>51?. Such preventive safety

measures reduce the risk of starting the tool

accidentally.

!%$&!&%

Move reverse switch lever to the center “OFF”

position. Remove battery pack and rotate the

clutch ring to the drill bit symbol

“ ”. Rotate the chuck sleeve counter-

clockwise viewing from chuck end, and open

chuck to approximate drill bit diameter. Insert

a clean bit up to the drill bit flutes for small

bits, or as far as it will go for large bits. Close

chuck by rotating the chuck sleeve clockwise

and securely tighten by hand (Fig. 2).

; :;@ A?1 @41 <;C1> ;2

@41 0>588 C4581 3>-?<5:3

/4A/7@;8;;?1:;>@534@1:.5@ Friction burn

or hand injury is possible if attempting to

grasp the spinning chuck.

!

WARNING

$ "(!'

Rotate the clutch ring to the drill bit

symbol “ ”. Open the chuck all the way,

remove left-hand thread screw inside chuck

by turning it clockwise (Fig. 3).

Insert the short arm of a 3/8" hex key wrench

and close jaws on flats of wrench (Fig. 4).

Strike long arm of wrench sharply

counterclockwise, remove wrench and

unthread chuck from spindle.

!%&!'

Always keep the spindle threads, the threads

of the chuck and securing screw free of

debris. To install a chuck, reverse “re moving

the chuck” procedure.

FIG. 3

FIG. 4

"<1>-@5:3:?@>A/@5;:?

($%#"!&$"

&$$%)&

Your tool is equipped with a variable speed

trigger switch. The tool can be turned "ON" or

"OFF" by squeezing or releasing the trigger.

The speed can be adjusted from the minimum

to maximum nameplate RPM by the pressure

you apply to the trigger. Apply more pressure

to increase the speed and release pressure to

decrease speed (Fig. 1).

!

WARNING

CHUCK SLEEVE

FIG. 2

SCREWDRIVER

BIT

BIT HOLDER

SCREWDRIVER BIT

CHUCK SLEEVE

BM 2610025599 05-12_BM 2610025599 05-12.qxp 5/1/12 1:42 PM Page 9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 47 48

Comments to this Manuals

No comments