Bosch SGE63E06UC/51 User Manual download pdf (Page 8)

Hot Water Supply

The hot water heater should be set to deliver approximately

120° F (49° C) water to the dishwasher. Water that is too

hot can cause some detergents to lose effectiveness. Lower

water temperatures will increase run times. The hot water

supply pressure must be between 15 - 145 psi (1 - 10 bar).

IMPORTANT NOTES:

 

sure to make all solder connections before connecting the

water supply line to the dishwasher.

 



· Always use the appropriate seal when making plumbing

connections.

· Before connecting the water supply line to the dishwasher,



to clear any foreign material.

· Turn on the water supply and check for leaks after

connections are made.



1. Remove the dishwasher electrical supply junction box

cover and connect to the power supply cord from the

house installation. (see Figure 5).

2. Remove 2” to 3” (51 - 76mm) of the outer casing of the

Figure 6.

Remove 3/8” to 1/2” (10 - 13mm) of the insulation from

each wire as shown in Figure 6.

3. Insert the bare copper or green wire(ground) to the

“G” ground connection “ “ of the terminal block

and securely tighten the terminal block screw (see

Figure 5).

4. Insert the white (neutral) wire to the “N” connection of

the terminal block and securely tighten the terminal block

screw.

5. Insert the black(hot) wire to the “L” connection of the

terminal block and securely tighten the terminal block

screw.

6. Check all electrical connections to make sure they are

secure and then attach the junction box cover with the 4

screws.

Avoid Electrical Shock Hazard

To avoid possible injury or property damage,

care should be exercised when the dishwasher is

installed or removed to reduce the likelihood of

damage to the power cord.

WARNING

Temperatures required for soldering and sweating

will damage the dishwasher. If plumbing lines

are to be soldered or sweated, keep the heat

source at least 6 inches (152.4 mm) away from

the dishwasher.

Avoid Scald Hazard

Do not perform any work on a charged hot water

      

plumbers should perform plumbing work. Do not

attempt any work on the dishwasher hot water

supply plumbing until you are certain the hot water

supply is shut off.

WARNING

3/8" - 1/2"

(10mm - 13mm)

2" - 3"

(51mm - 76mm)

Figure 6

Inlet Water Connections

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 38 39

Comments to this Manuals

No comments

Bosch SGE63E06UC/51 User Manual Page 8

Comments to this Manuals

Related products and manuals for Dishwashers Bosch SGE63E06UC/51