Bosch SME88TD01E Instruction Manual download pdf (Page 33)

Operating the appliance en

33

Time preselection

You can delay the start of the

programme by up to 24 hours.

Depending on the setting of the time

display, the end of programme is

indicated with “Finish in” (for example

3h 25m) or “Finish at” (for example

15:20 hours).

1. Open the door.

2. Switch on ON/OFF switch (.

3. Selects programme 0.

4. Press time preselection button `.

5. Keep pressing the setting buttons + -

X until the displayed time

corresponds with your requirements.

6. Press START button )", timer

programming is activated.

7. To delete the time preselection,

press START button )" for approx.

3 seconds.

Time preselection was terminated.

8. Close the door.

Programme end

* The programme has ended when

“Finished” is indicated on the display

window at the top @ and on the front

display * ):.

* The end of the programme is

displayed on the floor – provided the

TimeLight (optical display) is switched

on and is visible.

* depending on the features of your

dishwasher

Switching off the appliance

Short time after the end of the

programme:

1. Open the door.

2. Switch off ON/OFF switch (.

3. Turn off tap (does not apply to

appliances with Aqua-Stop).

4. Remove the utensils when they have

cooled down.

About the Eco drying function:

When Eco drying is activated in the

Eco 50° programme, the door opens

automatically when the programme

ends. This ensures the best possible

drying result. Low amounts of steam

may occur. If you install the appliance

under a worktop, fit the supplied

steam protection film * (follow the

procedures in the installation

instructions). The steam protection film

protects sensitive fitted furniture and

worktops from damage by water

vapour. Before opening the appliance,

leave it to cool down for a while in the

remaining programmes when the

programme ends.

* depending on the features of your

dishwasher

Interrupting the programme

Caution!

Expansion (overpressure) may cause

the appliance door to jump open and/or

water to escape! If the door was opened

on an appliance which has a hot water

connection or is heated, always leave

the door ajar for several minutes and

then close.

1. Open the door.

2. Switch off ON/OFF switch (.

The LEDs go out. The programme

is saved.

3. To continue the programme, switch

on the ON/OFF switch ( again.

4. Close the door.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 51 52

Comments to this Manuals

No comments