Bosch D1257 Installation Guide download pdf (Page 50)

D7212GV3 | Operation and Installation Guide | 13.0 Programmer Connections

50 Bosch Security Systems, Inc. | 10/10 | F01U143079-03

13.2 Installer Keypad and Local

Programmers Mode

While installing or maintaining a D7212GV3 control

panel, it is sometimes necessary to change the

configuration. To do so, a local keypad programming

menu is available in the Service Menu. You can

access the Service Menu when the control panel is in

stand-by mode or while it is operating. Refer to the

D7212GV3 Control Panel Program Entry Guide

(P/N: F01U170808) for an explanation of the

programming menu.

Accessing Local Keypad Programming when the

Control Panel is Operating (Reset Switch Open)

To access the Local Programmers Menu while the

control panel is operating:

1. Disarm all areas in the control panel.

Local keypad programming is only accessible

when all areas are disarmed.

2. At any D1255 or D1260 Keypad, press

[9][9][ENTER] to access the Service Menu.

3. Enter the Service passcode when prompted.

4. Advance the menu to the Keypad Programming

option, then press [ENTER] to enter programming

mode.

The Keypad Programming menu is only available

when all areas in the control panel are disarmed.

Accessing Local Keypad Programming when the

Control Panel is in Standby Mode (Reset Switch

Closed)

The control panel is in standby mode when the Reset

pin is closed. Refer to Figure 23 on page 49. While

the control panel is in standby mode, you can access

the Service Menu at one of two keypads with the

following restrictions:

• An unsupervised D1260 Keypad (all versions)

at SDI Bus Address 8.

The D1260 Keypad does not support SDI Bus

Address 16.

• An unsupervised D1255 Keypad (all versions)

at SDI Bus Address 16.

If a D1255 is set to SDI Bus Address 8, then

that keypad cannot be used to access the

Service Menu.

• Only one keypad at a time is allowed to be in

use.

To access Local Keypad Programming when the

control panel is in standby mode:

1. From the keypad (D1260 at SDI Address 8 or

D1255 ad SDI Address 16), enter the Service

Passcode.

2. Advance the menu to the Keypad Programming

option.

3. Press [ENTER] to enter Local Keypad

Programming.

13.3 Programmer Access Reports

When a program is sent to the control panel from

RPS, the control panel sends a Prog Access OK.

The prompt in routing must be programmed Yes to

send this report.

If the control panel is configured with the Reset switch

closed, then this report is deferred until after the

switch is unlocked.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 56 57 58

Comments to this Manuals

No comments

Bosch D1257 Installation Guide Page 50

Comments to this Manuals

Related products and manuals for Fire protection Bosch D1257