Bosch B36ET71SN Owner's Manual download pdf (Page 11)

Required accessories and tools

Supplied accessories

– Installation instructions

– Operating instructions

– Installation kit

Optional accessories

Extreme Combination Side-by-Side Heating kit

If the gap between the appliances is less than 6" (160 mm).

Other required accessories from

specialist outlets

Ice maker installation kit

" OD copper line

For connecting appliances which require water, e.g. for an

ice maker.

Maximum outer diameter of the water pipe (without fittings):

" (10 mm).

Tools

– Cordless screwdriver T20

– Torx screwdriver T20

– Torx bit T20 + magnetic holder

–

" (8 mm) hex nut driver

– Wood drills in different sizes

– Open end wrench

" (SW 13 mm)

– Multigrip pliers

– Adjustable wrench

– Cutter with adjustable blade

– Metal tape measure

–Square

– Spirit level length 2' (60 cm) and 4' (1,2 m)

– Marking-out level, length at least 4' (1.2 m) for individual

appliances or 7' (2.0 m) for Side-by-Side installation

Other

– Stepladder

– Dolly, hand truck

– Hammer drill for drilling holes in wall or floor

– Bits according suitable for material and in different sizes

– Wooden beam (cross section min. 3" x 4" (75 cm x 100

cm) as an alternative tilt protection, length according to

the width of the installation cavity

– Wooden screws in different sizes

– Thin (max.

" (1.5 mm)), suitable material to protect

the floor from damage (e.g. lino)

– Suitable material for covering and protecting furniture

(e.g. protective sheets)

– Adhesive tape

NOTE

Before using, check whether the removed adhesive

tape leaves adhesive residue on the work surfaces!

Otherwise do not use on high-quality work surfaces.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 71 72

Comments to this Manuals

No comments

Bosch B36ET71SN Owner's Manual Page 11

Comments to this Manuals

Related products and manuals for Fridges Bosch B36ET71SN