Bosch DHD User Manual download pdf (Page 13)

Page 11

Step 7: Mount Integral Blower or

Outlet Duct Transition for Re-

mote Blower

Integral Blower DHG601DUC (See

Figures 10 and 12 for further detail):

A. Attach blower in front of round exhaust

outlet with 4-6 (depending on configura-

tion) #8 sheetmetal screws

B. Feed cord from blower through strain

relief.

C. Secure strain relief with screws.

D. Attach strain relief to downdraft near

junction box.

E. Connect cord to downdraft at 6 pin con-

nector

F. Connect blower to ductwork.

Remote Blower DHG6003UC or

DHG1003UC (See Figures 11 and 12 for further

detail):

A. Remove junction box cover and connect

conduit with 5 wires from remote blower.

Hook up wires per Wiring Diagram,

Fig. 10. Replace junction box cover.

B. Attach duct transition at mounting holes

with sheetmetal screws.

C. Feed remote blower pigtail through strain

relief.

D. Attach strain relief to downdraft near

junction box.

E. Connect pigtail to downdraft at 6 pin

connector.

F. Run pigtail wires to junction box.

G. Inside junction box, connect conduit with

five wires from remote blower. Use a

conduit connector to secure.

Note: Blower and duct transition box may be

installed with duct outlet left, down or

right. Install blower or duct transition in

such a way that access panels can be

removed for service.

Strain Relief

Junction Box

Conduit To

Remote Blower

Figure 11 - Remote Blower

Figure 10 - Internal Blower

Internal Blower

Strain Relief

Transition

DHZDHR6

6 Pin

Connector

Remote Blower

Pigtail

6 Pin Connector

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 41 42

Comments to this Manuals

No comments