Bosch CPA565GS0B Instruction Manual Page 21

  • Download
  • Add to my manuals
  • Print
  • Page
    / 48
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 20
Steam en
21
Caution!
The appliance may become damaged due to the use of
unsuitable liquids.
Do not use distilled water, highly chlorinated tap water
(>40 mg/l) or other liquids.
Only use fresh, cold, non-carbonated tap water or
softened water.
Notes
If your water is very hard; we recommend that you
use softened water.
If you use only softened water, you can set your
appliance to the "softened" water hardness range.
1. Briefly press on the centre of the tank cover.
The tank cover will open. The drip tray (left) and
water tank (right) can now be accessed.
2. Remove the water tank from the tank recess.
3. Fill the water tank with cold water up to the "max."
mark.
4. Place the water tank back into the tank recess and
slide it in fully.
5. Close the tank cover.
The steam function is ready to use.
Refilling the water tank
The way the appliance responds if the water tank runs
dry when the appliance is in operation depends on what
operating mode it is in:
Steam-assistance mode: The appliance is stopped
and a message appears on the display.At the
highest steam setting, a tankful of water will last
approx. 30-40 minutes; at the lower steam settings,
it will last much longer.
Steam-assistance with microwave: The appliance is
stopped. A tankful of water will last approx.
50 minutes.
Steam-assisted hot-air or grill mode: The appliance
continues to run in hot-air or grill mode; no message
appears on the display. At the highest steam setting,
a tankful of water will last approx. 3 hours; at the
lower steam settings, it will last much longer.
Steam-assisted air recirculation grill mode: The
appliance continues to run in air recirculation grill
mode; no message appears on the display. A tankful
of water will last approx. 9 hours.
Note: Actual times may vary from those specified.
Refill the water tank up to the "MAX" mark.
1. Open the control panel.
2. Remove and refill the water tank.
3. Insert the filled water tank and close the control
panel.
After every steam operation
Moisture remains in the cooking compartment. Carefully
wipe out the drip channel and the cooking
compartment. Each time you cook using steam, we
recommend that you run the Rinse cleaning function !
afterwards. Then empty and dry the water tank and drip
tray.
Note: Remove limescale marks with a cloth soaked in
vinegar, then wipe with clean water and dry with a soft
cloth.
Rinsing
To ensure that your appliance stays clean, you can
pump water through the pipe system. The water is then
drained to the drip tray.
Starting
1. Use the function selector to select the rinse cycle !.
The duration of the programme will be displayed.It
cannot be changed.
2. Open the tank cover.
3. Remove and empty the drip tray.
4. Slide the empty drip tray in fully.
5. Remove water tank and drain any residual water.
Rinse out water tank thoroughly and fill with fresh
water.
6. Slide the water tank in fully.
7. Close the tank cover.
1 2
Page view 20
1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 47 48

Comments to this Manuals

No comments