Bosch 1617EVSPK Specifications download pdf (Page 10)

CHIP DEFLECTOR

Always wear eye protection.

The chip deflector is not

intended as a safety guard.

The chip deflectors help keep dust and chips

out of your face, it will not stop objects larger

than dust thrown from the bit.

To remove chip shield from bases, press

inward on tabs until it releases from base and

remove. To attach, place deflector into position

as shown in (Fig. 10). Then flex sides of

deflector while pushing until it snaps into place.

The plunge base’s chip shield can also be

flipped out.

INSTALLING TEMPLET GUIDE ADAPTER

Place templet guide adapter over the holes in

the center of the sub-base, and align the two

threaded holes in the bottom of adapter with

the countersunk holes in sub-base. Fasten

adapter with the screws provided. Note that the

adapter is reversible, so the release lever may

be positioned as desired. (Fig. 9)

-10-

TEMPLET GUIDE

ADAPTER

MOUNTING SCREWS

FIG. 9

FIG. 10

WARNING

• To position switch on the left, line up the

base’s arrow with arrow on the motor

housing that is below the switch.

3. Slide motor into base until resistance in felt.

(The base’s guide pin is now engaged into

slot on motor.)

4. Turn the motor clockwise until it stops.

5. Push the motor into the base as far as it will

go.

6. Fasten the base clamp lever.

BM 2610908996 5/03 5/20/03 9:06 AM Page 10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 67 68

No comments

Bosch 1617EVSPK Specifications Page 10