Bosch MRP23EVS Specifications download pdf (Page 15)

PLUGGING THE MOTOR INTO

THE OUTLET / LED LIGHTS

Whenever the motor is plugged in and

receiving power, the LEDs at bottom of the

motor light up. The LEDs enhance the visibility

of the work area when setting the depth and/or

starting location, as well as when routing. Note

that the motor cannot be turned on when not

installed in a Bosch MR-Series router base.

The motor should always be

unplugged when it is

necessary to reach into the bit area or make

adjustments in the bit area, such as when

changing bits, templet guides and/or

centering the subbase, for examples.

ELECTRONIC VARIABLE

SPEED CONTROL

The electronic speed control feature allows

motor speed to be matched to cutter size and

material hardness for improved finish,

extended bit life, and higher performance.

Speed changes are achieved by rotating

Control Dial RIGHT to increase speed, LEFT

to decrease as indicated on housing (Fig. 1).

Speed may be changed while tool is on. The

reference numbers on the dial facilitate re-

setting control to desired speed.

The speed chart indicates the relationship

between settings and application, exact

settings are determined by operator experience

and preference. The bit manufacturer may also

have a speed recommendation.

CORD SWIVEL

The power cord features a ball-joint swivel to

provide more flexibility in positioning the power

cord. It is mounted off of center on the rear of

the tool in order to minimize the number of

situations where the cord is directly over an

intended routing line.

SOFT START FEATURE

Electronic feedback control minimizes torque

twist customary in larger routers by limiting

the speed at which motor starts.

CONSTANT RESPONSE™ CIRCUITRY

The router's Tachometer-Feedback Constant

Response™ Circuitry monitors and adjusts

power to maintain the desired RPM for

consistent performance and control.

Operating Instructions

-15-

DIAL

SETTING RPM APPLICATION

1 10,000

2 13,000

3 16,000

4 19,000

5 22,000

6 25,000

}

}

Hardwoods,

nonferrous metals,

larger diameter bits

and cutters

Softwoods, plastics,

counter tops, smaller

diameter bits and

cutters

R

outing

L

ine

Cord

S

wivel

FIG. 12

!

WARNING

BM 2610004573 07-09:BM 2610004573 04-09 9/4/09 7:07 AM Page 15

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 79 80

Comments to this Manuals

No comments