Bosch SN350-34C-RT Installation Guide download pdf (Page 10)

10.

Cold Weather Operation

When using the tool in cold conditions the tool will cycle

slower than usual while driving the first nails. The cycle rate

will increase as the tool warms up. Keep tool warm to avoid

reduced cycle rate.

Do not use a frozen tool. Allow tool to thaw

before using. Moisture frozen in the tool may

impede internal components resulting in the risk of injury

and/or tool damage.

Nail Unloading

Always disconnect tool from air supply

before removing nails from magazine.

This avoids the risk of unintentional operation.

Do not disconnect air hose from the tool

with finger on trigger or work contact

element depressed. The tool can fire when reconnected to

air supply.

1. Disconnect air supply.

2. Pull back nail follower until it latches - FIG 13.

3. Remove nails from magazine.

4. Discard any collated nail strips that contain fewer than five

(5) nails.

5. Pull the nail follower a second time to release the latch,

and carefully allow the follower to slide forward until it

reaches the top of the magazine.

Do not allow the nail follower to freely

recoil. Guide the follower by hand until it

reaches its full forward position. Free recoil of the

follower could result in damage to the follower and/or

magazine or your fingers could become pinched.

Depth of Drive Adjustment

The depth with which nails are driven into the work piece

can be adjusted using the depth adjustment on the nose

piece of the tool - FIG 14.

Disconnect the tool from the air source

before making adjustments. Such

precautionary safety measures reduce the risk or

unintentional tool operation.

1. Disconnect tool from air supply.

2. Remove nails from tool as described in the “Nail

Unloading” section of this manual.

3. Adjust tool driving depth:

• To reduce the nail depth, turn the adjustment knob

clockwise - FIG 15.

• To drive the nail deeper, turn the adjustment knob

counter clockwise - FIG 16.

Operation

Adjustment

Knob

Work Contact

Element

FlushToo Deep

Turn the adjustment knob clockwise.

Turn the adjustment knob counter clockwise.

Too Shallow

Flush

FIG. 14

FIG. 13

FIG. 15

FIG. 16

WARNING

BM 2610957373 10-08:BM_2610957373 10-08.qxp 1/6/12 1:08 PM Page 10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 41 42

Comments to this Manuals

No comments

Bosch SN350-34C-RT Installation Guide Page 10

Comments to this Manuals

Related products and manuals for Power tools Bosch SN350-34C-RT