Bosch Xeo Operations Instructions download pdf (Page 17)

1 609 929 L29 • 19.9.07

English | 17

Declaration of Conformity

We declare under our sole responsibility that the product described under

“Technical Data” is in conformity with the following standards or standardi-

zation documents: EN 60745 (battery powered products) and EN 60335

(battery chargers) according to the provisions of the directives

89/336/EEC, 98/37/EC (until Dec. 28, 2009), 2006/42/EG (from Dec. 29,

2009 on).

Technical file at:

Robert Bosch GmbH, PT/ESC, D-70745 Leinfelden-Echterdingen

2007

Made in PRC 2007,

Robert Bosch GmbH, Power Tools Division

D-70745 Leinfelden-Echterdingen

Assembly

Battery Charging (see figure A)

f Do not use other battery chargers. The supplied battery charger is

designed for the Lithium-Ion battery in your machine.

The Li-ion battery is protected against deep discharging by the “Electronic

Cell Protection (ECP)”. When the battery is empty, the machine is switched

off by means of a protective circuit: The inserted tool no longer rotates.

Do not continue to press the On/Off switch after

the machine has been automatically switched

off. The battery can be damaged.

The battery is supplied partially charged. To ensure full capacity of the bat-

tery, completely charge the battery in the battery charger before using your

power tool for the first time.

A battery that is new or has not been used for a longer period does not

develop its full capacity until after approx. 5 charging/discharging cycles.

When the battery charge-control indicator 7 lights up red while the On/Off

switch 1 is pressed, then the battery has less than 30% of its capacity and

should be charged.

• Plug the mains plug of the battery charger into a socket outlet and the

charger plug 9 into the socket 8 on the rear side of the handle.

The battery charge-control indicator 7 indicates the charging progress. The

indicator lights up red during the charge procedure. The battery is com-

pletely charged when the indicator lights up green.

During the charging procedure, the handle of the machine warms up. This

is normal.

Disconnect the battery charger from the mains supply when not using it for

longer periods.

Do not use the machine during the charging procedure.

f Protect the battery charger against moisture!

Observe the notes for disposal.

Dr. Egbert Schneider

Senior Vice President

Engineering

Dr. Eckerhard Strötgen

Head of Product

Certification

WARNING

OBJ_BUCH-377-005.book Page 17 Wednesday, September 19, 2007 2:16 PM

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 111 112

Comments to this Manuals

No comments

Bosch Xeo Operations Instructions Page 17

Comments to this Manuals