Bosch NTC-255-PI User Manual download pdf (Page 79)

IP Camera 200 Series Advanced Mode | en 79

Bosch Security Systems Installation and Operation Manual AR18-10-B012 | v1.5 | 2011.01

6.8 Network

6.8.1 Network Access

The settings on this page are used to integrate the device into a

network. Some changes only take effect after a reboot. In this

case Set changes to Set and Reboot.

1. Make the desired changes.

2. Click Set and Reboot.

The device is rebooted and the changed settings are activated.

If the IP address, subnet mask, or gateway address is changed,

then the device is only available under the new addresses after

the reboot.

Automatic IP assignment

If a DHCP server is employed in the network for the dynamic

assignment of IP addresses, activate acceptance of IP

addresses automatically assigned to the device.

Certain applications (Bosch Video Management System, Archive

Player, Configuration Manager) use the IP address for the

unique assignment of the device. If using these applications,

the DHCP server must support the fixed assignment between IP

address and MAC address, and must be appropriately set up so

that, once an IP address is assigned, it is retained each time the

system is rebooted.

IP address

Enter the desired IP address for the camera. The IP address

must be valid for the network.

Subnet mask

Enter the appropriate subnet mask for the set IP address.

Network

> Network Access

> Advanced

> Multicast

>FTP Posting

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 103 104

No comments

Bosch NTC-255-PI User Manual Page 79