Bosch HGIP054UC User Manual download pdf (Page 6)

English 3

Replace Cooktop Orifices

1. Remove Grates, Burner Caps and Burner Bases.

Unscrew two (2) T20 screws inside each base and

remove burner bases. Reinsert screws in jet holder to

hold tubing assembly in place.

2. Remove Natural Gas Cooktop Orifices.

Insert the socket driver with 3" minimum extension into

the jet holders to remove existing orifices. Set natural

gas orficies aside.

3. Assemble LP Cooktop Orifices.

Place in cooktop exactly as laid out in the orifice card. If

the orifices become separated from the card,

placement can be determined by matching the number

and/or color on the orifice with the placement

specifications displayed in the chart on the card

4. Place the new orifice into the socket then insert each

orifice into its respective threaded hole in the jet holder.

Tighten until the orifice stops turning. DO NOT OVER

TIGHTEN.

5. Remove screws to replace burner base, burner cap

and burner grate. Replace screws.

Note: Burner cap must be properly positioned on

burner base for burner to light.

6. Place natural gas orifices in back of card for future

conversion back to natural gas.

Convert Cooktop Valves for Propane

Use

1. Verify that all knobs are in the OFF position

2. Remove knobs (pull straight out)

3. Insert 1/8” (or smaller) flat head screwdriver into shaft

and turn bypass screw clockwise until it stops (bypass

screw is inside shaft). DO NOT OVERTIGHTEN.

4. Replace knobs.

If your range is dual fuel your conversion is complete.

Replace the cover plate and warming drawer and pro-

ceed to “Test the Installation” on page 4.

For gas range conversions, continue to next step.

Adjust Broil Burner Orifice

1. Remove oven door (See section "Removing Oven

Door" in Use and Care manual).

2. Remove Broil Burner Assembly. The broil burner

assembly is attached to the top of the oven cavity with

5 screws. Remove screws and gently pull broil burner

assembly straight out being careful not to detach

electrical wires. Place broil burner against back wall of

oven cavity.

3. Use 1/2 inch (13 mm) wrench to remove the natural

gas orifice and install the separate LP gas orifice

provided. The orifice is located inside the oven cavity at

the top right (visible with burner assembly removed.)

Burner Grate

Burner Cap

Burner Base

Orifice

Ignitor

SIM

Bypass Screw Inside Shaft

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

Comments to this Manuals

No comments

Bosch HGIP054UC User Manual Page 6

Comments to this Manuals

Related products and manuals for Stoves Bosch HGIP054UC