Bosch HGIP054UC User Manual download pdf (Page 8)

English 5

Test Cooktop Burners:

Each burner must be tested for proper lighting, proper

flame characteristics on the low setting and proper flame

characteristics on the high setting.

Test for proper ignition:

1. Push down and turn the knob to ignition symbol.

2. Verify that the ignitor/spark module clicks.

3. Once the air has been purged from the supply lines,

verify that the burner lights within four (4) seconds.

After burner lights, turn knob to the off position.

4. Test each rangetop burner in this fashion. Call Service

if any of the burners do not light.

Test flame characteristics on the low setting:

1. Push in and turn the knob to the ignition symbol until

the burner ignites.

2. Turn knob to the low setting.

3. Verify that the burner maintains a minimum, steady,

flame without going out. The flame should not lift or

blow off of the burner. It should carry over, or surround,

the entire burner.

4. Verify that the flame is the right color. It should be blue

with an inner and outer cone. “Checking Flame

Characteristics” on page 7 for more information.

5. Test each rangetop burner in this fashion. If any flame

goes out, does not carry over properly or is too large,

contact service.

Test flame characteristics on the high setting:

1. Push in and turn the knob to the ignitor symbol until the

burner ignites.

2. Turn knob to the high setting.

3. Verify that the burner maintains a steady flame. The

flame should not lift or blow off of the burner. It should

carry over, or surround, the entire burner.

4. Verify that the flame is the right color. It should be blue

with an inner and outer cone. See Figure 6: Checking

Flame Characteristics for more information.

5. Test each rangetop burner in this fashion.

If any flame does not carry over properly, adjust the bypass

jet. Return to “Convert Cooktop Valves for Propane Use”

on page 3. If any flame burns yellow, contact Service.

Dual Fuel appliance installation is complete when cor-

rect color, carryover and size are verified on each

cooktop burner.

For gas appliances, continue to “Test Broil Burner” on

page 5

Test Broil Burner

Test Ignition

Set cooking mode to Hi Broil. The burner will ignite after

30-75 seconds.

Test Flame

Verify that flame characteristics are as shown in “Checking

Flame Characteristics” on page 7. If flame characteristics

are not consistent with those in the graphic above, adjust

the flame as describerd below. Otherwise, continue to

“Test Bake Burner”.

Adjust Broil Flame (if necessary)

Adjust the air shutter to alter the flame characteristice. The

air shutter is located on the back end of the broil burner.

Yellow Flames:

Further adjustment is required.

Yellow Tips on Outer Cones:

Normal for LP Gas.

Soft Blue Flames:

Normal for Natural Gas.

If the flame is completely or mostly

yellow, verify that the regulator is set for the correct fuel. A

retest.

Some yellow streaking is normal during the initial start-up

4-5 minutes and re-evaluate.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Comments to this Manuals

No comments

Bosch HGIP054UC User Manual Page 8

Comments to this Manuals

Related products and manuals for Stoves Bosch HGIP054UC