Bosch 23612 User Manual download pdf (Page 8)

-

8

-

Operating Instructions

INTENDED USE

This tool is intended for the fastening and

loosening of bolts, nuts and various threaded

fasteners. This tool is not intended for use

as a drill.

COLLET LOCKING SLEEVE

Insert a tool holder or screwdriver bit into the

chuck. Pull the collet locking sleeve forward.

Insert the desired bit into the chuck and

release the collet locking sleeve. The collet

accepts only standard 1/4” hexagonal shank

accessories with power groove. Do not use

this tool as a drill. Tools equipped with shut-

off clutches are not designed for drilling

applications. The clutch can shut off

automatically and without warning.

Attempting to restart drilling after shut-off has

been reached can cause the tool to twist out

of your hand until the clutch again reaches

shut-off. Do not attempt to insert quick-

change type drill bits into this chuck.

REMOVING A TOOL HOLDER, SOCKET

OR SCREWDRIVER BIT

Pull the collet locking sleeve forward. Take

the tool out of the chuck and release the

collet locking sleeve (Fig. 2).

VARIABLE SPEED CONTROLLED

TRIGGER SWITCH

Your tool is equipped with a variable speed

trigger switch. The tool speed can be

controlled from the minimum to the maximum

nameplate RPM by the pressure you apply to

the trigger. Apply more pressure to increase

the speed and release pressure to decrease

speed.

FORWARD/REVERSING LEVER &

TRIGGER LOCK

Your tool is equipped with a forward/

reversing lever and trigger lock located above

the trigger (Fig. 1). This lever was designed

for changing rotation of the chuck, and for

locking the trigger in an “OFF” position to help

prevent accidental starts and accidental

battery discharge. For forward rotation, (with

chuck pointed away from you) move the lever

to the far left. For reverse rotation move the

lever to the far right. To activate trigger lock

move lever to the center off position.

Do not change direction of

rotation until the tool

comes to a complete stop.

Shifting during

rotation of the chuck can cause damage to

the tool.

BELT CLIP (Optional Accessory)

When the tool is attached to

the belt, position yourself to

avoid entanglement with surrounding objects.

Unexpected entanglement could cause the

tool to fall resulting in injury to the operator or

bystanders.

The optional belt clip accessory will allow you to

conveniently attach your tool to your belt. This

feature will allow you to have both hands free

when climbing a ladder or moving to another

work area.

The belt clip can be attached to either side of

the tool by securing it with a mounting screw.

Always make sure you securely tighten the

mounting screw before use.

To open clip, squeeze both release buttons

and the clip will spring up automatically

(Fig. 3). To use clip, turn tool upside down and

attach to your belt.

To retract clip when not in use, push down on

clip until it locks in the closed position.

!

WARNING

!

CAUTION

COLLET

LOCKING

SLEEVE

CLIP

RELEASE

BUTTONS

CHUCK

FIG. 2

FIG. 3

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments