Bosch GSN Specifications download pdf (Page 13)

English | 27

Bosch Power Tools 1 609 929 U15 | (8.12.09)

Changing the Workpiece Protector (see figure H)

The workpiece protector 1 at the end of the discharge

lock-off 2 protects the workpiece until the pneumatic tool

is correctly placed for the driving procedure.

The workpiece protector can be removed and replaced.

– Remove spring clip 23 and pull the workpiece protec-

tor from the discharge lock-off 2.

– Push the new workpiece protector over the discharge

lock-off and mount the spring clip again.

Stationary Use of the Pneumatic Tool (see figure I)

For stationary use, the pneumatic tool can be fastened to

a balancer.

The screwable eyelet 24 is required for this.

– Remove the rear screw of the exhaust cap with the

supplied Allen key.

– Screw the eyelet 24 firmly into the exhaust cap.

– Hook the eyelet to the balancer hook.

Transport and Storage

For transport, disconnect the pneumatic tool from the air

supply; especially when using ladders or moving in an un-

usual stance or posture.

At the workplace, carry the pneumatic tool only by the

handle 5 and with the trigger 10 released.

Always store the pneumatic tool disconnected from the

air supply and at a clean and dry location.

When not using the pneumatic tool for a longer period of

time, cover steel parts with a fine oil coating. This pre-

vents the formation of rust.

Maintenance and Service

Maintenance and Cleaning

Disconnect the air supply before making any

adjustments, changing accessories, or plac-

ing the pneumatic tool aside. This safety

measure prevents accidental starting of the

pneumatic tool.

If the pneumatic tool should fail despite the care taken in

manufacture and testing, repair should be carried out by

an authorised customer services agent for Bosch power

tools.

In all correspondence and spare parts orders, please al-

ways include the 10-digit article number given on the type

plate of the pneumatic tool.

f Have maintenance and repair work carried out only

through qualified persons. This will ensure that the

safety of the pneumatic tool is maintained.

An authorized Bosch after-sales service agent will carry

out this work quickly and reliably.

Lubricating the Pneumatic Tool (see figure J)

When the pneumatic tool is not connected to a mainte-

nance unit, it must be lubricated at regular intervals:

–For light-duty use 1x per day.

–For heavy-duty use 2x per day.

Apply 2

–3 drops of lubricant into air connector 6. Do not

apply too much lubricant, which could then accumulate in

the pneumatic tool and be emitted via air outlet 4.

Use only the lubricants recommended by Bosch.

– SAE 10 mineral engine oil (for use at very cold ambient

conditions)

– SAE 20 mineral engine oil

Observe all applicable environmental regulations when

disposing of old grease and solvents.

OBJ_BUCH-1037-001.book Page 27 Tuesday, December 8, 2009 1:03 PM

1 2 ... 8 9 10 11 12 13 14 15 16 17

Comments to this Manuals

No comments

Bosch GSN Specifications Page 13

Comments to this Manuals

Related products and manuals for Unknown Bosch GSN