Bosch TAS3202GB Instruction Manual download pdf (Page 9)

5 en

Problem Cause Solution

The brewing unit cannot

be opened.

The brewing unit is still

locked.

Wait until the Status LED S has stopped blink-

ing before attempting to open the

brewing unit.

If the brewing unit stays locked, contact the

TASSIMO careline.

Fill water tank R

lightsup.

There is not enough

water in the water tank.

Fill the tank with cold, fresh water as far as the

max mark. Reinsert the water tank.

Fill water tankR lights

up even though there

is enough water in the

water tank.

The ﬂoat in the water

tank is stuck.

Clean the water tank and free the ﬂoat.

The water tank is not

inserted correctly.

Check that the water tank has been correctly

inserted.

Fill water tank R and

Descale Q are ﬂashing

simulta neously and it is

not possible to prepare

drinks.

There is a fault on the

machine.

Turn the machine oﬀ using the On / Oﬀ switch,

wait approximately 5 minutes and turn the

machine back on. If R and Q are still ﬂashing,

please contact the TASSIMO careline.

Descale Q lights up or

starts ﬂashing.

The appliance needs to

be descaled.

Descale the appliance. Please refer here to the

section áDescaling.

Descale Q lights up

or starts ﬂashing even

though decalciﬁed water

has been used.

Even decalciﬁed water

contains low amounts of

calcium carbonate.

Descale the appliance. Please refer here to the

section áDescaling.

The quality of the crema

has deteriorated.

The beverage outlet is

sticky or dirty.

Clean the beverage outlet. Please refer here to

the section àCleaning.

Clean the brewing unit with the yellow Ser

-

vice TDISC. Please refer here to the section

àCleaning.

Build-up of limescale in

the appliance.

Descale the appliance. Please refer here to the

section áDescaling.

Water is dripping from

the brewing unit.

The TDISC is damaged

or leaky.

The TDISC has not been

pierced cor

rectly.

Do not use TDISCs that are damaged.

Only use each TDISC once.

W

ait until t

he brewing stage has come to

an end and the appliance has cooled down.

Remove the TDISC and clean the brewing unit.

Please refer here to the section àCleaning.

The piercing unit has not

been inserted correctly.

Press the piercing unit into its holder using

both thumbs (until an audible click is heard).

On the surface below

the cup stand there is

water.

This is condensation. Condensation may appear and is not caused

by any fault with the appliance. Wipe the water

away with a cloth.

Troubleshooting

H

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 29 30

Comments to this Manuals

No comments