Bosch DIE945E Instruction Manual download pdf (Page 16)

16

Replacing the light bulbs

1. Switch off the extractor hood and pull

out the mains plug or switch off the

electricity supply at the fuse box.

 When switched on, the halogen bulbs

become very hot. Even for some time after

the bulbs have been switched off there is

still a risk of burns.

2. Remove the bulb ring with a screwdriver

or similar tool. Fig. 4

3. Replace the halogen light bulb

(conventional halogen bulb, 12 Volt,

max. 20 Watt, G4 cap).

Caution: Refer for plug-in lampholder.

Fig. 5.

Take hold of the bulb with a clean cloth.

4. Re-insert the bulb ring.

5. Plug the appliance into the mains or

switch it on at the fuse box.

Note: If the light does not function, check

that the bulbs have been inserted correctly.

If you encounter a problem

If an

#

or

ã

appears in the display:

❑ See "Filters and maintenance" Section.

If is not possible to operate the extractor

hood:

❑ Disconnect the extractor hood from the

mains electricity supply by pulling out the

plug or switching it off at the main fuse

box.

Wait for approx. 1 minute and then

switch it on again.

If you have any questions or if a fault

occurs, please call Customer Service.

(See list of Customer Service

representatives).

When you call, please quote the following:

Setting the saturation indicator

If it becomes necessary to change the

operating mode (exhaust-air/recirculating

mode), the saturation indicator for the ﬁlters

must also be altered (see Installation

Instructions).

E-Nr. FD

Enter the relevant numbers into the box

above. The E-Nr. (product no.) and FD

(production date) are shown on the

nameplate which can be seen inside the

extractor hood after the ﬁlter frame has

been detached.

The manufacturer of the extractor

hoods accepts no liability for complaints

which can be attributed to the design

and layout of the pipework.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 87 88

Comments to this Manuals

No comments