Bosch 0 607 595 100 Operations Instructions download pdf (Page 17)

English–6

2 609 929 157 • (04.08) T

Installing the Saw Blades

Unscrew the two knurled nuts 8 nd remove them to-

gether with the lock washers and the faceplate 9.

Choose the saw blade set 7 that matches the saw

blade guide 5 (see Accessories). Two serrated saw

blades move side by side in opposite directions within

the saw blade guide.

Put the saw blade set 7 together. Take care that the

unground sides of the saw blades are placed against

each other (and the printing on the saw blades is read-

able.

Insert the saw blade set 7 with the lengthwise slots into

the guide pin 12 of the saw blade guide 5.

Push the saw blades into the saw blade guide 5 and

slide them in individually as far as the respective stop

14 of the drive block.

The cross-slots of the saw blades should fit into the

catch pins of the drive blocks 13. The saw blades 7

should lie, as shown in the picture above, between the

drive blocks.

Tightly screw back on the face plate 9 with the knurled

nuts 8 and the lock washers.

Check that the saw blades are seated firmly in

the tool before you connect the tool to the air

supply. Saw blades that are not clamped properly in

the appropriate holder may slip out and can cause

damage to the workpiece or injury to you or others.

Installing the Footplate

Press the footplate 6 onto the saw blade guide 5.

Firmly tighten the clamping screw 15.

FoamC_bu_2609929157_t.fm Seite 6 Dienstag, 10. August 2004 12:36 12

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 133 134

No comments

Bosch 0 607 595 100 Operations Instructions Page 17