Bosch WTMC6321CN Operations Instructions download pdf (Page 5)

Please ask your dealer or inquire at

your local authority about the current

means of disposal.

Before installing the dryer

Unpacking the appliance

The dryer is very heavy. Do not

lift it by yourself. Do not lift the

appliance by projecting

components (e.g. door) - due to

risk of breakage.

Remove the appliance

packaging carefully to prevent

damage to the surfaces.

Check the dryer for transportation

damage. Do not connect a dryer which

is visibly damaged. If in doubt, contact

your dealer.

Supplied components

For U.S.A.

The dryer is supplied without

a power cord. The power cord

must be connected by qualified

persons only.

After removing the packaging,

immediately remove any objects

from the drum.

The dryer is delivered as a complete

unit. The operating instructions and

supplied accessories can be found in

the drum.

Installation location

Do not install the dryer:

- outdoors

- in an environment with dripping

water,

- near flammable materials,

- in rooms which are at risk of frost,

- in rooms which may contain gas

or other fuels,

- in cupboards with Iockable doors

or in alcoves.

The installation room must be well

ventilated, otherwise the dryer will

operate below optimum performance.

Do not operate the dryer at

temperatures above 104°F (40°C) and

below 41°F (5°C). Low temperatures

affect the automatic program sequence

and may prolong the drying times.

The installation surface for the dryer

must be clean, level and firm. Do not

install the appliance on carpets!

Compensate for uneven floors with the

height-adjustable feet.

Install the dryer and level side to side

and front to back. Use a bubble level.

Never remove the height-adjustable

feet!

The size of the installation area

depends on the dimensions of the

dryer. Ensure that there is adequate

room for the swivel range of the door!

a

Dimension Weight

a 27.0"(686 mm) 125Ibs

b 31.8"(808 mm) (56kg)

with

c 37.2"(945 mm) packaging

d 19,7" (500mm)/ 143Ibs

angle 170-180° (64kg)

Ifinstalling the dryer in a closet, observe

the minimum distances according to

the following table:

Minimum Installation Clearances

Closet

Sides 0" (0 ram)

Top 12" (305mm)

Rear* 0" (0 mm)

* as closeto wallas ventingwill allow.

Important information concerning

minimum distances:

- Depending on the location of the

exhaust air connection, an

additional minimum distance of

51/2inch (14 cm) must be provided

on this side for pipes/brackets (see

page 7).

- Distances above the indicated

minimum dimensions reduce the

risk of mold formation behind the

appliance.

- Additional distances reduce noise

transmission.

- Additional distances facilitate

installation and service.

- Ifthe dryer is installed in a small

room, the doors of the room must

be fitted with vents of a specified

minimum size.

The dryer door is delivered with hinges

on the right. If required, the door hinges

can be switched to the left side.

If the door hinges are to be changed

over, please contact your dealer or our

customer service-team (see page 22).

1 2 3 4 5 6 7 8 9 10 ... 71 72

Comments to this Manuals

No comments