Bosch WORCESTER GREENSTORE Installation Manual Page 2

  • Download
  • Add to my manuals
  • Print
  • Page
    / 12
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 1
INTRODUCTION
The Greenstore cylinder shell is made from Stainless Steel for excellent
corrosion resistance. Greenstore cylinders have a strong steel case and
are well insulated with environmentally friendly insulation.
They are available in two sizes, 180 and 280 litres, both with a
supplementary coil for use with solar or other fuels. For other fuels, you
may need to source a dual thermostat for control purposes.
UNPACKING THE UNIT
Greenstore cylinders come complete with all the
fittings required to complete the installation:
• Inlet Control set
• 15mm / 22mm Acetal Tundish
• Expansion vessel
• Wall mounting bracket
• Expansion vessel hose
• Thermostat for second energy input.
(1 x manual reset - high limit stat for solar)
• Installation & Maintenance Instructions
• Hot water sensor GT3 (Supplied with cylinder)
2 INTRODUCTION
Worcester Bosch Greenstore
Expansion
Vessel
Expansion
Vessel Hose
High Flow Rate
Inlet Control
Set
Installation &
Maintenance
Instructions
Acetal
Tundish
Wall
Mounting
Bracket for
Expansion
Vessel
The Greenstore cylinder is supplied complete with all the necessary, pre-adjusted, safety and control devices needed to
connect to the cold water supply mains.
High quality controls have been selected to combine high flow rate performance with minimum pressure drop to allow the
Greenstore cylinder to perform well in areas, where there is a minimum dynamic working mains pressure of 1.5 bar.
Greenstore cylinders are KIWA approved and comply with Building Regulations KIWA sections G3 and Part L1.
STORAGE PRIOR TO INSTALLATION
The Greenstore cylinder should be stored upright in the original packaging and in an area free from excessive moisture.
IMPORTANT NOTE TO THE INSTALLER
Read these installation and maintenance instructions carefully before commencing work. Unvented cylinders are a
controlled service as defined in the latest edition of the building regulations and must only be fitted by a qualified person.
The relevant regulations are: England and Wales - Building Regulations G3,
Scotland - Technical standard P3,
Northern Ireland - Building Regulation P5
After installation, the benchmark log, in the back of this manual, must be completed and left along with
these instructions with the householder for future reference.
Solar High
Limit Stat
Page view 1
1 2 3 4 5 6 7 ... 11 12

Comments to this Manuals

No comments