Bosch VG4-A-PSU0 Installation Guide download pdf (Page 21)

AutoDome Pipe Mount Installing the Pipe Mount | en 21

Bosch Security Systems, Inc. Installation Guide F.01U.251.410 | 1.0 | 2011.08

2.6 Installing the VG4-A-9543 Pipe Mount

This section details the installation steps for the VG4-A-9543

Pipe Mount.

Figure 2.5 Pipe Mount

1. Before installing the Top-Mounting Flange, ensure there is

an adequate opening in the ceiling or mounting structure

for the wires to pass through.

2. Secure the pipe Flange with supplied gasket to the ceiling

or other supporting structure using four (4) 10-mm (3/8-

inch) diameter fasteners.

NOTICE!

Customer must supply 1-1/2 inch (NPS) pipe threaded on both

ends with a minimum length of 5 inches (12.7 cm).

1Gasket

2 Flange

3Cap

5 in.

12.7 cm

min.

NOTICE!

Each fastener must have a minimum pullout strength of 275 kg

(600 lbs). The mounting material must be able to withstand this

pull-out force. For example, 19-mm (3/4-inch) minimum for

plywood.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 51 52

No comments

Bosch VG4-A-PSU0 Installation Guide Page 21