Bosch VG4-A-PSU0 Installation Guide download pdf (Page 30)

30 en | Installing the Pipe Mount AutoDome Pipe Mount

F.01U.251.410 | 1.0 | 2011.08 Installation Guide Bosch Security Systems, Inc.

3. Drop the Pendant down slightly to engage the dome hook

and hinge pin of the Dome Cap, allowing the dome to

rotate around the hinge pin.

4. Rotate the dome housing down to a vertical position and

gently push upward to engage the connector on top of the

dome housing.

5. Hold the housing firmly in position and alternately tighten

the two (2) 5-mm Allen head mounting screws from above

to a torque value of 10-12 N-m (90-105 in.-lbs).

6. Rotate the arm to swing the AutoDome out from the roof

and into position.

7. Tighten the three (3) 10-mm (3/8-inch) stainless steel hex

bolts on the bracket to lock the Parapet Arm in position.

Refer to Figure 2.9, Page 29, for an illustration.

CAUTION!

If you feel any resistance when rotating the dome housing or

when engaging the connector, stop immediately and start over.

CAUTION!

You must tighten the two mounting screws to a minimum

torque of 10-12 N-m (90-105 in.-lbs) to ensure a proper seal

between the arm and the housing.

CAUTION!

Do not over tighten the bolts. The maximum torque is 34 N-m

(25 ft-lb).

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 51 52

No comments

Bosch VG4-A-PSU0 Installation Guide Page 30