Bosch DVA-12T Installation Manual download pdf (Page 56)

56 en | Subsystem Maintenance RAID Subsystem DVA-16K | Installation Manual

F.01U.027.799 | V2 | 2008.08 Bosch Security System

6.7.2 Replacing a Hard Drive

When a hard drives fails, it needs to be replaced. To replace a hard drive, please follow these

steps:

1. Identify the drive tray that contains the hard drive that needs to be replaced.

2. Open the key-lock. To remove the drive tray from the enclosure, the key-lock must be

unlocked. (See Figure 6.20) To do this, turn the key-lock on the front of the drive tray

until the groove on its face is in a horizontal orientation.

Fig. 6.20 Drive Tray Key-lock Rotation

3. Open the front flap by pushing the button at the front of the drive tray. (See Figure 6.21)

The drive tray front flap will automatically be lifted and the drive tray will be dislodged

from the chassis.

Fig. 6.21 Front View of an Individual Drive Tray

4. Remove the drive tray with the hard drive, gently and carefully withdrawing the drive tray

with hard drive from the chassis.

5. Remove the four (4) retention screws located on the sides of the drive tray (two on each

side.) (See Figure 6.22)

CAUTION!

The hard drive is fragile—always handle with extreme care. Do not drop the hard drive; always

be slow, gentle, and careful when setting down a hard drive. Only handle the hard drive by the

edges, and avoid touching any components or connectors.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 71 72

No comments

Bosch DVA-12T Installation Manual Page 56