Bosch WAU28460IN Installation Manual download pdf (Page 40)

en Cleaning and maintenance

40

After the water has cooled down:

1. Turn off the water tap so that no

more water can flow in and has to be

drained via the drain pump.

2. Switch off the appliance.

3. Disconnect the mains plug.

4. Open and remove the service flap.

5. Take the drain hose out of the

retainer.

Remove the sealing cap, allow the

water to flow out into a suitable

container.

Replace the sealing cap and place

the drainage hose in the retainer.

6. Carefully unscrew the pump cover,

residual water may leak out.

Clean the interior, pump cover

thread and pump housing. The

impeller in the detergent solution

pump must be able to rotate.

Refit the pump cover and screw it on

tightly. The handle must be in a

vertical position.

7. Place the service flap back on, lock

it into place, and close it.

Note: To prevent unused detergent

from flowing straight into the drain

during the next wash, pour 1 litre of

water (without detergent) into

compartment II and start the 0 Spin

programme. Do the next wash as usual.

The drain hose at the siphon

is blocked

1. Switch off the appliance.

2. Disconnect the mains plug.

3. Loosen the hose clamp. Carefully

remove the drain hose; residual

water may leak out.

4. Clean the drain hose and siphon

connecting piece.

5. Reattach the drain hose and secure

the connection using the hose

clamp.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 46 47 48

Comments to this Manuals

No comments