Bosch WAU28460IN Installation Manual download pdf (Page 43)

Faults and what to do about them en

The water is not draining. ■ Is “- - - -” selected (Rinse Stop = no final drain)?

■ Clean the drain pump ~ Page 39

■ Clean the drain pipe and/or the drain hose.

Water is not visible in the

drum.

Not a fault – the water is below the visible area.

The spin result is not sat-

isfactory.

Laundry is wet/too damp.

■ Not a fault – the unbalanced load detection system has interrupted the spin

cycle because the laundry is unevenly distributed.

Distribute small and large items of laundry evenly in the drum.

■ Anti-crease (depending on the model) selected?

■ Is the selected speed too low?

The spin cycle runs sev-

eral times.

Not a fault – the unbalanced load detection system is adjusting an imbalance.

The program is taking

longer than usual.

■ Not a fault – the unbalanced load detection system is adjusting an imbal-

ance by repeatedly distributing the laundry.

■ Not a fault – the foam detection is system active – a rinse cycle has been

switched on.

The length of the program

changes during the wash

cycle.

Not a fault – the program sequence is optimised for the specific washing pro-

cess. This may change the length of the program shown in the display panel.

Residual water in the

care-product compart-

ment i .

■ Not a fault – the effect of the care product is not affected.

■ Clean the insert if necessary.

Odours in the washing

machine.

Depending on the model, run the Drum Clean Û 90 °C or i Cottons 90 °C

program without laundry.

Add washing powder or a detergent containing bleach.

Note: To prevent foaming, only use half the amount of detergent recommended

by the detergent manufacturer. Do not use detergents designed for wool or del-

icates.

The Åsymbol lights up

in the display panel. Foam

may also be leaking from

the detergent drawer.

Have you used too much detergent?

Mix one tablespoon of fabric softener with 1/2 litre of water and pour it into

compartment II (not suitable for outdoor clothing, sportswear or items stuffed

with down).

Use less detergent in the next wash cycle.

Loud noises, vibrations

and machine "move-

ment" during the spin

cycle.

■ Is the appliance aligned? Align the appliance ~ Page 18

■ Are the appliance's feet fixed? Secure the appliance's feet ~ Page 18

■ Have the transport braces been removed?

Remove the transport braces ~ Page 15

The display panel/indica-

tor lights do not work

while the appliance is run-

ning.

■ Has there been a power failure?

■ Have the fuses blown? Reset/replace the fuses.

■ If the fault occurs repeatedly, call customer services.

Faults Cause/Remedy

1 2 ... 38 39 40 41 42 43 44 45 46 47 48

Comments to this Manuals

No comments

Bosch WAU28460IN Installation Manual Page 43

Comments to this Manuals

Related products and manuals for Washing machines Bosch WAU28460IN