Bosch DIE165R Installation Manual download pdf (Page 27)

We reserve the right to construction changes within the

context of technical development.

Preparing the ceiling

❑

The ceiling must be ﬂat and horizontal.

❑

Ensure that the ceiling is capable of pro-

viding a ﬁrm hold for mounting screws

and plugs. The enclosed plugs are sui-

table for concrete and stonework. If the

ceiling is made of any other material,

use appropriate mounting components.

Weight in kg:

Prior to installation

Changing over from exhaust-

air to recirculating mode

Changing the electronic control system

to recirculating mode:

❑

The standard factory setting is for

operation in exhaust-air mode.

❑

To change the mode, the extractor hood

must have been connected up and

should be switched off.

1. Press and hold the 0 and

0 button.

2. While

{ is displayed, press the +

button until

ã is displayed. When this has

taken place, release the buttons.

❑

ã goes out shortly afterwards.

The electronic control system will then

have been set to recirculating mode.

❑

By repeating steps 1 and 2, you can

change the electronic control system

back to exhaust-air mode (

# in display).

Electrical connection

WARNING: THIS APPLIANCE MUST BE

EARTHED

IMPORTANT: Fitting a Different Plug:

The wires in the mains lead are coloured in

accordance with the following code:

Green and Yellow – Earth

Blue – Neutral

Brown – Live

If you ﬁt your own plug, the colours of

these wires may not correspond with the

identifying marks on the plug terminals.

This is what you have to do:

1. Connect the green and yellow (Earth)

wire to the terminal in the plug marked

‘E’ or with the symbol ( ), or

coloured green or green and yellow.

2. Connect the blue (Neutral) wire to the

terminal in the plug marked ‘N’ or

coloured black.

3. Connect the brown (Live) wire to the

terminal marked ‘L’, or coloured red.

The extractor hood should only be

connected to an earthed socket that has

been installed according to relevant

regulations.

If possible, site the earthed socket directly

above the chimney panelling in the ceiling.

Electrical data:

Are to be found on the name plate inside

the appliance after removal of the ﬁlter

frame.

 Before undertaking any repairs,

always disconnect the extractor hood from

the electricity supply.

Length of the connecting cable: 1.30 m.

If it is necessary to wire the extractor

hood directly into the mains:

The extractor hood should only be

connected to the electricity supply by a

properly qualiﬁed electrician.

A separator must be installed in the house-

hold circuit. A suitable separator is a switch

that has a contact gap of more than 3 mm

and interrupts all poles. Such devices

include circuit breakers and contactors.

 If the connecting cable for this applian-

ce is damaged, the cable must be replaced

by the manufacturer or his customer

service or a similarly qualiﬁed person in

order to prevent serious injury to the user.

This extractor hood corresponds to EC

regulations concerning RF interference

suppression.

27

Exhaust air Recirculating air

41,240,5

0

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 107 108

Comments to this Manuals

No comments