Bosch ART 26 Accutrim Operations Instructions download pdf (Page 17)

English - 3

17 • F016 L70 348 • TMS • 08.09.05

Charging Procedure

The charging procedure starts as soon as the mains

plug is plugged into the socket and the battery 13 is

inserted into the charging compartment 16.

Due to the intelligent charging method, the charging

condition of the battery is automatically detected and

the battery is charged depending on battery temper-

ature and voltage.

This gives longer life to the battery and always

leaves it fully charged when kept in the charger for

storage.

Control of the charging procedure is indicated via

the charge control LED 14:

Rapid charging

The rapid-charging procedure is in-

dicated by flashing of the charge

control LED 14.

The battery is fully charged as soon as the LED 4

switches from flashing to being lit continuously. Af-

terwards the battery can be removed for immediate

use.

It is recommended not to remove the battery until the

battery is fully charged.

☞

The rapid-charging procedure is possible only

when the temperature of the battery is be-

tween 0 °C and 45 °C.

Trickle charging

The trickle-charging procedure is in-

dicated by continuous lighting of

the LED 4.

With the battery fully charged, the charger immedi-

ately switches to trickle-charge mode. This equal-

izes the natural running-down of the battery again.

Charging Advice

With continuous or several repetitive charging cy-

cles without interruption, the charger can warm up.

This is not harmful and does not indicate a technical

defect of the unit.

A battery that is new or has not been used for a

longer period does not develop its full capacity until

after approximately 5 charging/discharging cycles.

A significantly reduced working period after charging

indicates that the batteries are worn out and must be

replaced.

Do not connect the battery before product

is completely assembled.

Ensure product is assemble in the following or-

der:

Mounting the Cutting Guard

Place the cutting guard 10 on the trimmer head 8.

➊ Hook the guard onto trimmer head and push until

secure fitting.

➋ Push rear of guard until secure (click).

Mounting the Wheels (ART 26/2600 ACCUTRIM

only)

Fit the wheels 11 onto the shaft 6.

Fit the bolt 19 and the wingnut 18.

Note: The position of the wheels can be adjusted by

loosening the wingnut 18 and moving to the desired

position.

The wheels can be moved up and down the

shaft 6 depending on the height of cut required.

Fitting Cutting Disc/Fitting Blade

Press cutting disc 20 onto drive adaptor as

shown (click).

Fit the blade, place the blade 22 over the

pivot 21 and pull outwards until it snaps into place.

For Your Safety

Warning! Switch off, remove battery from ma-

chine before adjusting or cleaning.

The blade continues to rotate for a few sec-

onds after the trimmer is switched off.

Caution – do not touch rotating blade.

Assembly

F016 L70 348 - GB Seite 3 Donnerstag, 10. November 2005 10:11 10

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 98 99

Comments to this Manuals

No comments

Bosch ART 26 Accutrim Operations Instructions Page 17

Comments to this Manuals

Related products and manuals for Cordless hedge trimmers Bosch ART 26 Accutrim